Recently, a number of car companies have filed a recall plan with the State Administration for Market Regulation and recalled some models. The reasons for the recall are various, and the recall of Wang Benz is still not left behind.
1. BMW Brilliance
Effective December 24, 2021, the recall will be made of the domestic BMW iX3 electric vehicle with production dates from April 30, 2021 to August 27, 2021.
The reason for the recall is poor welding quality at the pins of the internal contact system of the power battery in some vehicles, which may cause deviations in the actual and measured values of temperature/voltage.
The possible consequence is that when the deviation value exceeds the set safety value, the vehicle will start the battery system fail-safe mode, the fault code or alarm prompt information will appear, and cut off the power battery output, causing the power interruption during the vehicle's driving, and there is a safety hazard.
The recall measure is to replace the power battery module with welding defects free of charge for vehicles covered by the recall.
Lao Hou commented: Excited heart, trembling hands, do I have any on the list of layoffs this time? Brilliance bankruptcy, of course, there will be a certain impact on BMW Brilliance, especially in terms of personnel, the changes will be relatively large. The operators on the production line must be worried, worried that if they are laid off, the work will be prone to mistakes. Therefore, stable people's hearts are the basic guarantee of high-quality production.
2. Chrysler (China)
With effect from December 30, 2021, the recall will be made of some imported Wrangler vehicles manufactured between January 20, 2021 and August 30, 2021.
The reason for the recall is due to the reasons of the instrument combination software, which may cause the vehicle to fail to display the mileage value normally after driving 21473 kilometers (or 13342 miles), which does not meet the requirements of the relevant national mandatory standards.
The possible consequences are that the user of the vehicle may miss or delay important vehicle maintenance, and if there is a potential failure of the vehicle part due to lack of maintenance, it may cause an accident without prior warning, and there is a safety hazard.
The recall measure is software for vehicles to upgrade the meter, and for vehicles that no longer display mileage values, the instrument combination is replaced
Lao Hou comments: Second-hand car dealers can pat their chests this time to assure you, I definitely did not adjust the table! This is a second-hand ladies boutique car, which has only run more than 20,000 kilometers in ten years. But he won't tell you that the car has only been maintained five times in ten years, and the last one was three years ago.
3. Changan Ford
Effective January 20, 2022, the Company will recall some 2021 Forres vehicles manufactured between January 4, 2021 and August 9, 2021.
The reason for the recall is that the vehicle uses the in-car double pull unlock method to open the hood, but it lacks the "hood is not closed" prompt function.
The possible consequences are that if the hood is not fully locked after opening, the driver may be difficult to recognize the state in the car, and in extreme cases, the hood of the vehicle is at risk of being lifted, affecting the driver's line of sight, increasing the risk of collision of the vehicle, and there is a safety hazard.
The recall measure is to install a "hood not closed" notification function for vehicles within the scope of the recall free of charge to eliminate safety hazards.
Lao Hou commented: Driving the car, the hood is on the face, this is not sour, but fatal! But just adding a "hood not closed" prompt function should not be enough, right? Don't you know that there are a lot of people who drive without looking at the dashboard? I think it is necessary to install a locking device for the hood, which is not allowed to be opened without manual operation, so as to ensure absolute safety.
4. Mercedes-Benz
Effective April 29, 2022, the recall will be made of certain imported AMG GT vehicles with a production date from July 17, 2015 to March 15, 2017.
The reason for the recall is that the vehicle's carbon fiber drive shaft may have residues from the production process attached to its bonded surface to the flange, causing its adhesion to the flange to be affected.
The possible consequence is that the connection between the carbon fiber drive shaft and the flange may separate during the operation of the vehicle, resulting in damage to the gearbox. In extreme cases, there may be power interruption during the driving process of the vehicle, which increases the risk of collision of the vehicle and has a safety hazard.
The recall measure is to inspect the carbon fiber drive shaft for the vehicles within the scope of the recall, and if it is the part number in the affected area, it will be replaced free of charge to eliminate the safety hazard.
Lao Hou commented: The recall of the king is indeed worthy of the name, and the recall does not fall down. Before the screw can not be tightened, now is the transmission shaft manufacturing process defects, what moths will appear in the back? It seems that the quality control of Mercedes-Benz cars is indeed a problem, is it not easy for arrogant German workers to manage it? If you fire them all and hire a group of people from China, you will definitely be more responsible than them!