Today, a novice driver from abroad consulted Coach Shi, and when she reversed into the second half of the underground parking lot of the community, she found that the body was getting closer and closer to the left corner. With the help and guidance of the people next to him, he repeatedly adjusted it many times before he reluctantly poured the car into the middle of the car. The novice driver asked Coach Shi how to shunt the car quickly in this situation?
?
The principle of reversing and shunting has been explained many times in previous articles and videos. Although novice drivers can see clearly, due to the lack of training, when encountering the situation of reversing in the field, it is possible to think of the specific operation steps for a while.
Today's article uses the legend to explain, encounter the left library angle is getting narrower and narrower, how should I quickly shunt?
The first case: the positive angle is reversed into place
Reversing only needs two directions, the right inverted library (positive angle) and the left inverted library (reverse angle). Let's start with the positive angle reversing. If you reverse the second half of the car, you will find that in the following picture, the wheels are getting closer and closer to the left corner, or the rear of the car always obscures the position of the right headlights of the left car. That proves that you're playing late or too slowly.
?
In this case, even if you hit the full wheel, it will not help, let the car continue to turn, the consequence is to scratch the body next to it. Therefore, here to stop in time, hang up the front gear to drive the car forward, in the process of driving forward, there are two ways to deal with it.
Method 1: Directly swing the car straight. As shown in the figure below, the purpose of this is to compare the left and right widths of the car body with the edge of the library through the two rearview mirrors.
If you find a wide and a narrow, when reversing, use the method of borrowing one and paying back two taught before, first hit the wheel in the direction of the wide, and when the car goes to the two rear wheels and the distance between the left and right edges is almost equal to the width, the opposite direction returns to the wheel twice, and the car body will gradually become positive. After the car, turn the direction back to the right, and pour straight into it.
Way two: when traveling forward, it is also a wheel to the left while walking, but there is no need to correct the body, you can visually measure the radius of the wheel and the corner of the library through the right rearview mirror, about the height of a mineral water bottle. If you are not willing to lower the mirror, you can use the rear door handle instead of the wheel, and visually measure the radius of the headlight next to the circle center, about a foot or so.
Meet one of the conditions, you can hang the reverse gear, while walking to the right to hit the wheel, in the process of reversing, to always maintain this radius, when the car is right, just in the middle of the car.
Even if there is a small deviation, use the method of borrowing one and returning two mentioned earlier, fine-tune the steering wheel to adjust the car to the center position.
?
The second case: reverse angle into place
If you are reversing, there is a trend in which the left corner of the chart becomes smaller. It means that the time to play the wheel is early. There are also two ways to shunting.
Method 1: When the radius of the rear and the next headlight is less than half a foot, the direction is reversed, and the oblique retreat is until the left rear wheel and the library edge line are about 20 cm or so apart, or the rear door handle and the center point lamp, at an oblique 45 degrees into a line, about 30 cm or more spacing, to the left to hit the full wheel. The rear of the car is located right in the middle of the car.
Method two: the driver with stronger control and measurement ability, found that it is narrow, while walking, put the wheel to the right, until a satisfactory radius appears, re-fill the left, and the car will also be parked in the middle of the car.
?
Through the above demonstrations, as long as you master the principle of shunting, you can easily transfer the car to the center of the car. This is why I often tell students that reversing is easy to shunt. When you master the shunting skills, the ability to control the car will be greatly improved, no matter what form of reversing into place, it is a very easy thing for you.
Today's topic is here, welcome everyone to continue to pay attention to Coach Shi talking about driving, I will share more driving experience and car maintenance knowledge with you.