30 seconds to start without throttle half-slope:
1. When driving to the half slope, step on the brakes, step on the clutch, and slowly step on the two at the same time to park the car at the top of the slope. Raise the brakes, or make them neutral. At this point, if the brake or clutch is lifted, the vehicle stops steadily. After the ramp fixed stop is successful, the machine in the car will be displayed and start to start. Students must successfully start within 30 seconds.
2, release the handbrake, slowly lift the clutch, until the body shakes, the car gently shakes, on the flat road to release the brakes, the car will also move forward. However, on the ramp, please relax a little more before you feel the body shaking violently;
3. When the body shakes insufficiently, after releasing the brakes, steal the car. At this point, you can immediately stop the brakes, so that the clutch returns to its original state and then releases it slightly. At this point, the body usually shakes very strongly, so slowly relax the brakes. After getting into the car, rotate the steering wheel a quarter to the left, so that the body is not correctly uphill when the line is pressed, and the top of the uphill returns to the positive direction. At this time, it means that you have passed the exam. Just step on the brakes and clutch downhill.
Start-up sprint and flameout prevention:
For starters, there is no easiest way to start on a half-slope than to start without stepping on the throttle. Just turn off the clutch, but this method is limited. If the operation is not good and causes the ignition to stop, it can be handled as follows.
1. When you are ready to start, your left foot slowly begins to clutch. Wait for the vehicle to have a noticeable shake, slowly relax the brakes with your right foot, and be sure to relax slowly. The left foot can not relax, stabilize the clutch.
2. If the body of the car appears to slip at this time, do not panic, step on the brakes and clutches in time, and start again within 30 seconds.
3. If you accidentally turn off the ignition, please do not panic. At this point, depress the brakes and clutches to restore the range to neutral, and then ignite again.
The reason why the ramp starts to turn off is mostly because the vehicle reaches the semi-linkage limit point and the vehicle begins to shake, the left foot does not firmly hold the clutch, so it is necessary to grasp the lifting speed of the clutch here.
supplement:
Steep slope start without throttle method 1:
When starting on steep slopes, you usually use your right foot to brake. Release the left foot clutch to semi-linkage, and when releasing the clutch to shake the car, slowly release the brake. After slowly moving forward, the brakes can be completely relaxed. If you don't move, you can loosen up a little more and turn off the clutch. Slowly relax the brakes, feel the unit power out of the oil after refueling to start, use the hand brake, the clutch slowly lifted to the joint point, at this time immediately stabilize the clutch, put down the brakes with your hands, there will be a "slippery slope" phenomenon on the car.
Steep slope start without throttle method two:
When starting uphill, the resistance is large, and the clutch must be stable for 3-4 seconds compared to the flat road. When braking by hand, never release the clutch right away. Please refuel immediately and slowly lift the clutch when the car is slowly advancing 3-4m to avoid a smooth start on the ramp. When starting uphill and putting your hand on the brake, you must immediately refuel it so that the engine speed is about 1500 rpm. In this way, the starting power on the uphill of the car is enough, and there will be no "jitter". The key to whether you can start smoothly on the ramp lies in whether you can properly cooperate with your hands and feet. Failure to do so will cause the engine to stall and the car to skidd.