Click below to subscribe to the Beginner's Cheats Season 4 column to watch 50 episodes including this one
Now the vehicle is parked inward in the front of the car in the parking space, and the right side of the body is about 10 cm away from the pillar, and the left side of the car is about 60 cm apart.
The width of the aisle can only accommodate two cars barely able to drive,
The pillar in the back is almost at the same level as the parking space sideline, which is a big obstacle when reversing out of the garage.
There are often vehicles parked in the free parking space, so don't expect to occupy it when you reverse out of the garage.
Now hang up the reverse gear and prepare to reverse out of the warehouse, observe the right rearview mirror, and know the distance between the right body and the column.
Reversing in the direction of hitting the right can see that the front wheel is hitting the wheel to the right, and the rear wheel is swinging to the right.
From the rear view, it can be seen that the front wheels are in a state of full right-
In order to prevent the front left corner of the front from rubbing against the left vehicle when arcing to the left, in the direction of reversing in the direction of hitting the full right, it is necessary to reverse the direction by turning back to the left once.
Then hit the full direction to the right, and then go back to the left once in the direction of the reverse and then hit the right direction,
Reverse the car in such a zigzag way, and after a few cycles, when approaching, you can finally see the left front bumper and the left vehicle passing by at a very close distance.
Let's look at the process and direction of the right rear wheel turning through the column from the right rear point of view, although the front wheel is full of directions to the right at the beginning, but because the rear wheel is not a steering wheel,
Therefore, after the right rear wheel turns over the column, the radius of the reverse turn is still very large, and after the left front corner of the bumper is staggered with the left vehicle, the rear of the car is still blocked by the rear column.
In this way, it is necessary to adjust the body by going back to the left and returning one or even a few.
From the rear, the front of the car and the front of the car are not far away, and the rear is not very far from the pillar.
This requires the driver to have a more accurate distance judgment when moving forward and backward to adjust the body.
Now through the lower edge of the front windshield you can see the lower position in the middle of the headlights,
Hang up the front gear to the left full direction, when the front windshield under the edge of the front windshield can not see the headlights of the car, hang the reverse gear to the right to hit the direction of reversing.
Look at the left rearview mirror, pay attention to the change of light illuminated by the reversing lamp to the pillar, when the light hits the pillar more and more intensely,
In the end, when the light is barely scattered around, it means that the limit distance has been reached, and the stop is stopped immediately.
Hang up the forward gear and hit the left direction to continue to further adjust the body,
Stop in the right direction when the front bumper is close to the front car, hang the reverse gear and hit the right direction,
Look at the left rearview mirror and observe the relationship between the left rear corner and the column,
The rear of the car reversed backwards while turning to the right, and saw that the pillar and the body opened up a little gap,
As the gap widens, it is possible to fully pass, hit the left in the reverse direction until the direction is full, and then let the left front half of the car fall over the pillar,
Okay, the adjustment of the body out of the garage in the narrow environment is completed.
Dear old and new friends, a total of 50 videos of "Beginner Cheats - Season 4" have been updated