Bookcase installation process.
Hello everyone, let's see how the master shares how to install this bookcase, and then see how the master installs it so perfectly in the picture.
The first step is to take out the drawings and look at the floor plan to see where to start. Then take out a knife to cut out the mulch, and then use an air gun to blow the dust on the floor and wall with an air gun, especially the mud and sand of the switch box, and blow it clean. Then take the switch panel off and take it off, whether the electrician can't go down next time.
The most important thing in the next step is to take out infrared rays and check whether the ground and the top surface are high. Next, watch the master splice the four-centimeter base, and then level the base horizontally and take the cabinet up.
Next, watch Applejack install the glass cabinet light strip, the light strip needs to install three buttons, and then snap it into the belt slot. This light strip does not need to be fixed with glass glue, the reason is that there is a buckle, and the advantage of having a buckle is that it is easy to disassemble and assemble. Applejack then assembles the open cabinet. This open cabinet is a small thing to him, and Applejack is a professional cabinet.
Next, go back to the master to see how to find the left and right levels. Find it horizontally, move the glass cabinet up, and connect it to the right cabinet.
Next, call the imp to come and help lift this desk to position it first, then draw out this corner line, and then take it down and remove this corner. Then take the desk up and make sure the level is leveled.
Take out this iron frame and put it in the position where it needs to be drawn, and take out the impact drill to drill it four holes after the line is drawn, pay attention to whether there are water and electricity lines on the wall, otherwise it will be troublesome. Then fix the iron frame with German fischer expansion screws, then fix a board on the right wall, fix it on the right, and then put the desk on it and fix it, and then determine whether it is firm or not.
How about the next look at the rebound pump installed by the ghost? Seeing the little ghost like this, the master took him to 857 a lot at night.
Next, take the imp to pull the wire to the downlight port, and the transformer is placed here in the downlight to facilitate maintenance. Then draw out the notch line of the side plate on the right and cut it out, and take it up after the incision is cut to see if it can be put right. Then take it out and fix the left and right side panels to fix the whole cabinet. Pay attention to fixing, this shelf must be fixed with extension screws.
‧ Fix it and ask a few guys to lift the cabinet up together, can it be aligned? Carry this cabinet must be careful, if you accidentally put the countertop underneath, it will be bruised. Then pull out this open cabinet light cord and put it where you need it.
Take out the 12-ray infrared leveling and then fix, fix it with the German fischer expansion screw, you need to match the cover, you need to fix a few left and right, and fix it to see if the light strip is lit. Lift the glass cabinet up again, and then lift the open cabinet up again. Be careful to make an infrared leveling. Then fix the left light plate and fix the closing strip. Next, the imp put the drawers in place, and I cleaned them.
It's already dark, this is a good effect, it's a pity that these three glass doors have not yet arrived, these two pieces of glass are used as mirrors.
