How to make a TV cabinet?
The suspended TV cabinet is now decorated in 10 out of 10 and 8 want to do it, but most of the ones that have been done have stepped on the pit, either falling and deforming or separating from the wall, and some of them are falling directly from the farther and farther away. If you want to hang the TV cabinet to make a sense of high-class without stepping on the pit, you must remember the following 6 points.
First, if the length is less than 3 meters, do not consider making a suspended TV cabinet, too short to make is a word ugly. Making a two-meter cabinet is to save board and money, but now the 85-inch TV has a length of one meter seven or eight, hanging up is almost catching up with the length of the TV cabinet, making it disproportionate will be very ugly. And don't make the background wall as long as it is. If the background wall of your home is more than 4 meters 5, you can make a sideboard like this to the top, and then add a suspended cabinet, which looks more coordinated and atmospheric.
Second, no matter how long the proportion of the cabinet is, the best size is that the bottom should be suspended 20 cm, the height of the cabinet should also be 20 cm, and the width of the table should be 35 cm, which is the best looking ratio.
Third, the light strip will be played under the suspended TV cabinet, but if the light is used to hit the bright brick downward, the word is ugly. Because just like the ground installed with a light strip, if you hit it upwards and it will be dazzling and ugly, you must install this 45-degree hitting wall will not appear reflective, with matte bricks, bright bricks can be.
Fourth, make a suspended TV cabinet if you install a bright handle and an ugly word. If you want the cabinet to look more advanced, you must do this handle-free design.
Fifth, when the electrician is constructing, it is necessary to determine the size of the TV cabinet, and the five zero tubes must be pre-treated in advance, and the socket must be installed in the cabinet so that it is beautiful. But you must remember that the door of the socket must be made into an upturned door panel or a downward flip door panel, so that the socket can be put in, otherwise it cannot be put in as a drawer.
Sixth, the most important point is the fixed method.
If this wall of your house is a load-bearing wall, use expansion screws and tripods to fix it.
If your home is not a load-bearing wall, then you need to hollow out the wall, fill it with cement mortar later, and then fix it with expansion screws and tripods, then there is no problem.
If your bricklayer is over, you can let the carpenter fix the wall with two layers of base panels, which can basically solve the problem of falling deformation.
Pay attention to the seventh sister, decorate without stepping on the pit!
