Follow | Top
The fresh play content you bring every day will never make you regret it
Model Maker |@black57775
Kit | MG 1/100 Sniper Jim
tag | Model modification, detail addition, painting, and appreciation of masterpieces
After 31 days and a series of operations, @black57775 completed the modification of this MG Sniper Jim, not only the details of the organism, but also the specially made floor to match it. @black57775 has also done a sniper Jim modification before, but that one is mostly added to the engraving line on the outer armor, and this time 80% of the body is covered with new plastic plate details, resulting in a heavier body effect.
First, from the transformation process, see how many extra plywood boards are on the body to pile up the details.
The effect of the upper body, the head has made a lot of changes, adjusted the proportion of the top of the head, increased the crown, the mouth and cheeks have been changed, and there are Vulcan cannons on both sides.
The entire breastplate is covered with a layer of rubber plate, the missile is added inside the shoulders, a considerable amount of detail has been added above the chest, and the heat dissipation port on the chest is specially made detail.
There are also mounted weapons on both sides of the body, and there are also spring-loaded power tube parts at the bottom of the chest.
The part of the skirt armor is almost homemade, and the shoulder nail is also covered with half of the rubber plate, and the side shields made of the rubber plate are added on both sides of the shoulder.
Heavier armor was added to the sides of the calf, and the upper parts of the ankles were also hollowed out, and details of heat dissipation devices were added.
The exterior details of the sniper rifle have also been enhanced, with details of plywood and hoses added above and on the sides.
The platform is basically completely homemade.
The surface of the platform is a large piece of plywood with engraved lines.
The base of the energy tank is also made of plastic panels.
It works pretty well together.
After the transformation is basically completed, the body effect before the coating, the white rubber board can be seen to cover almost most of the area of the original kit. The rifle is also connected to the back as well as the energy tank by a conduit.
Finally, let's take a look at the effects from different perspectives