laitimes

The lack of update of the fastener caused the 12th generation Core processor to be bent: the magic change was increased and the temperature was lowered by 5 °C

Intel 12th Generation Core Alder Lake features a disruptive hybrid architecture of large and small cores with the new LGA1700 slot.

However, foreign media Igor's lab found that the LGA1700 socket fastener specifications were not adjusted according to the length of the processor, only at the two points in the center, that is, the red part of the figure below to apply pressure, but this will lead to inconsistent pressure direction of the processor, with pink line segments as the center of the U-shaped bend, together with the motherboard will also be affected by bending.

The lack of update of the fastener caused the 12th generation Core processor to be bent: the magic change was increased and the temperature was lowered by 5 °C

Igor's lab has been photographing the i9-12900K processor that has been used for a while and has produced visible bends to the naked eye.

Igor's lab said it didn't cause core damage to the processor, but due to uneven surfaces, the processor top cover was in poor contact with the heatsink, which affected heat dissipation.

As can be seen from the figure below, the silicone grease on the surface of the processor is mainly concentrated in the middle area, and there is almost no silicone grease on the upper and lower edges.

The lack of update of the fastener caused the 12th generation Core processor to be bent: the magic change was increased and the temperature was lowered by 5 °C
The lack of update of the fastener caused the 12th generation Core processor to be bent: the magic change was increased and the temperature was lowered by 5 °C

However, this problem can be avoided, that is, it is more testing of the user's hands-on ability. The solution given by Igor's lab is to disassemble the fastener that holds the processor in place, and then install gaskets of different thicknesses at the screw hole location, increasing the height of the buckle so that the pressure on the processor is as balanced as possible.

Igor's lab recommends operating in a flat surface environment, where the processor can be left inside the clip during the installation of the heightened gasket, which also protects very fragile processor pins. Since it is impossible to give a specific torque force, it is recommended to tighten it with bare hands when loading back the screw, which is really a "miracle of strength"...

The lack of update of the fastener caused the 12th generation Core processor to be bent: the magic change was increased and the temperature was lowered by 5 °C
The lack of update of the fastener caused the 12th generation Core processor to be bent: the magic change was increased and the temperature was lowered by 5 °C

Igor's lab tested washers of different thicknesses, all of which were fully tested by the oven, and the statistical result was that the 1.0mm gasket performed best, with a maximum reduction of 5.76°C.

The lack of update of the fastener caused the 12th generation Core processor to be bent: the magic change was increased and the temperature was lowered by 5 °C

Read on