preface
With the increasing power consumption of mobile electronic devices such as mobile phones and tablets, users have begun to pursue efficient and convenient mobile power products. Recently, when sorting out nearly 600 dismantling cases of mobile power banks in the past, it was found that a number of mobile power banks under Greenlink were equipped with protocol chips from Xinhai Technology, Yingjixin, Tiandeyu, Guangxin Micro and Zhirong to help products support the mainstream fast charging protocols on the market, so as to design high-performance mobile power products.
Over the years, the application cases of the main control protocol chip of the green power supply
The chips that appear in the article are shown in the table above, and the following editor will give you a detailed introduction.
Drawing the proportion of chip manufacturers in the article into a pie chart, it is found that Xinhai Technology has the highest proportion, reaching 40%.
In addition, the number of applications of a single chip was plotted into a bar chart, and it was found that the number of applications CS32G020K8U6 Tiandeyu FP6601Q and Xinhai Technology was the same, both of which were 3 times.
UGREEN new 25000mAh 145W fast charging power bank
Greenlink has updated its 145W mobile power supply, its product model and appearance have not changed, the 25000mAh capacity remains the same, but the output power has been improved, supporting PD3.1 140W fast charging. The total output power of the power bank remains unchanged, the USB-C1 interface has been increased from the original 100W output power to 140W output power, the USB-C2 interface output power has been increased from 45W to 65W, and the dual port 100+45W power distribution is supported.
Built-in protocol chip
UNICMICRO广芯微UM3506-BPQH
The USB-C1 140W interface adopts the UM3506-BPQH SOC chip of Broadchip, which is a fast charging controller that supports PD 3.1 specifications, with full-featured SRC/SNK/DRP support capabilities, fully meeting PD3.0, PD3.1 specifications, supporting SPR, EPR (PD3.1) mode, as well as chunk mode of PD packets and 260bytes long packets.
Chipsea芯海科技CSU3AF10
The protocol chip for USB-C2 and USB-A ports comes from Chipsea Technology, model CSU3AF10, which is a USB-C controller launched by Chipsea Technology that supports USB Type-C and PD3.0 fast charging protocols.
Related Reading:
1. Dismantling report: Greenlink's new 25000mAh 145W fast charging power bank
UGREEN绿联25000mAh 145W笔记本充电宝
Greenlink has launched a power bank that supports 145W output, this power bank supports 65W self-charging, supports 100+45W dual port simultaneous output, and can meet the emergency charging of two notebooks at the same time. The power bank has a built-in 25,000mAh battery with an energy of 90Wh, which can meet the requirements of taking planes and trains.
Built-in protocol chip
Chipsea芯海科技CS32G020K8U6
One of the USB PD protocol chips is from Chipsea Technology, with a model number CS32G020K8U6, which is a USB-C controller that supports USB-C and PD3.0 launched by Chipsea Technology.
Chipsea芯海科技CSU3AF10
The power bank also has a built-in CSU3AF10 protocol chip of Xinhai Technology, which is a USB-C controller launched by Xinhai Technology that supports USB Type-C and PD3.0 fast charging protocols.
Related Reading:
1. Dismantling report: Greenlink 25000mAh 145W laptop power bank
UGREEN 20000mAh 45W Bidirectional Fast Charging Power Bank
This mobile power supply of Greenlink adopts PC+ABS fireproof material shell, and the front and back of the fuselage are sun-grained, which is very textured and feels good. The battery capacity is up to 20,000mAh, and the battery life is strong; Equipped with 2C1A three interfaces, it supports 45W and 30W two-way fast charging, and supports Apple iPhone 12 20W fast charging, which can charge up to three devices at the same time, meeting the charging needs of laptops, mobile phones, headphones and other devices during long-distance travel.
Built-in protocol chip
Chipsea芯海科技CS32G020
The C1 and C2 port fast charging protocol chips are from Xinhai Technology, and the model is CS32G020. The chip is suitable for PC power adapters, mobile phone fast chargers, high-power mobile power supplies, car chargers, USB HUB and other fields.
JADARD天德钰FP6601Q
The USB-A port protocol chip adopts Tiandeyu FP6601Q, supports Qualcomm QC3.0/2.0 and Huawei FCP, and automatically adjusts the output voltage on the power supply device by monitoring the voltage data on USB D+/D-, and improves the charging power and shortens the charging time after handshaking and identifying each other. In the case of native support for QC3.0, QC2.0 and FCP, it can also automatically identify APPLE, Samsung, BC1.2 protocols.
Related Reading:
1. Dismantling report: Greenlink 20000mAh 45W two-way fast charging power bank
UGREEN绿联10000mAh磁吸无线充移动电源
This magnetic wireless charging power bank has a capacity of 10,000mAh and strong adsorption power, which can provide stable magnetic charging for iPhone 12, and is suitable for daily use. The overall fuselage is silver-gray, and the edge is designed with a decorative ring, which has a high overall appearance and a good feel to use.
Built-in protocol chip
INJOINIC英集芯IP5568
The main control chip of the mobile power supply adopts Yingjixin IP5568, which is an integrated wireless charging TX/RX, QC2.0/QC3.0/SCP output fast charging protocol, FCP/AFC/SFCP input and output fast charging protocol, MTK PE+ 1.1&2.0 output fast charging protocol, USB-C/PD2.0/PD3.0 input and output protocol, USB-C PD3.0 PPS output protocol, compatible with BC1.2/Apple/Samsung mobile phone, synchronous buck/buck converter, Lithium battery charge management, battery level indication and other multi-functional power management SOC, providing a complete power solution for fast charging power bank.
Related Reading:
1. Dismantling report: Greenlink 10000mAh magnetic wireless charging power supply
UGREEN MFi certified 10000mAh two-way fast charging power bank
UGREEN 10000mAh two-way fast charging power bank adopts PC+ABS flame retardant material shell, surface sun-grained treatment, rounded corners, and the overall is small, lightweight and easy to carry. The built-in Lightning cable saves iPhone users the trouble of being wired. The 1A1C port supports QC and PD fast charging respectively, and the USB-C port also has three sets of fixed voltage ranges of 5V2.4A, 9V2A and 12V1.5A. Three fast charging output modes can meet the charging needs of various devices.
Built-in protocol chip
Chipsea芯海科技CS32G020K8U6
内置Chipsea芯海科技CS32G020K8U6 32位MCU，该系列是芯海科技推出的支持USB Type-C和PD3.0协议的USB-C控制器。
Related Reading:
1. Dismantling report: Greenlink MFi certified 10000mAh two-way fast charging power bank
UGREEN绿联18W双向快充移动电源10000mAh FB171
The appearance of this product is round, the design is very simple, and the two-way fast charging function of a USB-C interface is used to realize the charging and discharging of the battery, and it is also equipped with a USB-A interface, which supports 18W fast charging output.
Built-in protocol chip
ISmartWare智融SW6106
The main control chip of the mobile power supply adopts Zhuhai Zhirong SW6106. This chip integrates a variety of protocols and buck-boost switch tubes, integrates 4A high-efficiency switch charging, 18W high-efficiency synchronous boost output, PD/QC/FCP/PE/SFCP and other fast charging protocols, power metering, lighting drive and corresponding control and management logic, is a highly integrated bidirectional fast charging mobile power bank dedicated all-in-one chip.
Related Reading:
1. Dismantling report: Greenlink 18W two-way fast charging power bank 10000mAh
UGREEN绿联18W双向快充移动电源10000mAh PB108
Greenlink 10000mAh 18W two-way fast charging mobile power supply has a sun-grained finish, which is more temperamental and feels good to use. The USB-C cable and A port both support QC2.0/3.0, AFC, FCP multiple fast charging protocols, good compatibility, and also support 5V/3A, 9V/2A, 12V/1.5A output, which can meet the fast charging needs of most mobile phones.
Built-in protocol chip
INJOINIC英集芯IP5322
The main control chip of the mobile power supply adopts Yingjixin IP5322. The IP5322 is a multi-functional power management SOC that integrates a synchronous buck-boost converter, Li-ion battery charge management, and battery level indication. It supports QC3.0/2.0, MTK PE+1.1&2.0 output fast charging protocol and FCP, AFC, SFCP input and output fast charging protocol, and is compatible with BC1.2, Apple, Samsung mobile phones, which can provide a complete power supply solution for fast charging power bank.
JADARD天德钰FP6601Q
In addition, it also has two built-in Tiandeyu FP6601Q protocol ICs.
Related Reading:
1. Dismantling report: Greenlink 18W two-way fast charging power bank 10000mAh
UGREEN MFi certified 20000mAh two-way USB PD fast charging power bank
Greenlink has launched a 20000mAh two-way fast charging power bank, which comes with a Lightning cable and has passed Apple's MFi certification, which is rare in the market. This product can not only carry out two-way 18W fast charging, but also has strong compatibility, and can quickly charge a variety of iPhones.
Built-in protocol chip
Chipsea芯海科技CS32G020K8U6
内置的USB Type-C控制器型号为CS32G020K8U6，来自MCU芯海科技。
JADARD天德钰FP6601Q
另一颗丝印FT4AZR芯片是天德钰FP6601Q快充协议IC。
Related Reading:
1. Dismantling report: Greenlink MFi certified 20000mAh two-way USB PD fast charging power bank
UGREEN绿联10000mAh双向快充移动电源
Greenlink 10000mAh two-way fast charging power bank is a small power bank with a built-in 10000mAh battery and supports 18W PD fast charging. It is very advantageous in terms of portability.
Built-in protocol chip
INJOINIC英集芯IP5332
W332 is the IP5332 all-in-one SOC chip of Yingjixin, which supports multiple USB ports at the same time, and supports a variety of fast charging protocols, integrates bidirectional PD function, and supports a variety of voltage batteries, covering all lithium batteries on the market, with a maximum charging current of 5A, a maximum support of 18W output, and a built-in fuel gauge function, a built-in power tube, a small number of peripheral components, the maximum simplified design and cost savings, and the chip supports lithium battery NTC temperature detection to ensure the safety of use.
Related Reading:
1. Dismantling report: Greenlink 10000mAh two-way fast charging power bank
UGREEN绿联10000mAh无线充移动电源
Greenlink has launched a new wireless charging power bank, with a capacity of 10000mAh, equipped with mainstream USB-A and USB-C interfaces, supporting a variety of fast charging protocols, achieving a maximum of 18W two-way wired fast charging, in addition to supporting Samsung 10W wireless fast charging, so the product can charge three devices at the same time (wired + wireless).
Built-in protocol chip
INJOINIC英集芯IP5328P
Yingjixin IP5328P integrated QC2.0/QC2.0/QC 3.0 output fast charging protocol, and has passed the QC3.0 Qualcomm certification, certificate number: 4788056908-2. Integrated FCP, AFC, SFCP, MTK PE, USB C DRP, BC1.2 input/output charging protocols. It is worth mentioning that IP5328P also supports PD3.0/2.0 fast charging.
Related Reading:
1. Dismantling report: UGREEN 10000mAh wireless charging power bank
Summary of the charging head network
By sorting out the dismantling data of 10 green mobile power banks in the article, the charging head network learned that in terms of chip types, 6 products choose to use the main control SOC chip, and the other products use protocol chips. In terms of the proportion of chip manufacturers, Xinhai Technology ranks first, with an actual proportion of 40%, and Yingjixin and Tiandeyu win the second and third places with a proportion of 27% and 20% respectively. In terms of the actual application times of a single chip, the two chips with the most applications are Tiandeyu FP6601Q and Xinhai Technology CS32G020K8U6, both of which have been applied 3 times.
The data in this article comes from the self-purchase and dismantling database of the charging head network, which is for reference only.