Preface
When you draw engineering drawings, you often have such a discovery, when some SOLIDWORKS annotations and annotations are used, and the national standard annotations and annotations are different, in order to ensure the drawing specifications, users need to make corresponding adjustments to the annotations and annotations of SOLIDWORKS engineering drawings.
1. Existing SOLIDWORKS cutting symbols
The cut symbol in SOLIDWORKS by default is usually a dashed line, as shown in the figure, and users may not be used to drawing drawings, so they will need to modify the style of the cut symbol.
Second, the national standard style cutting symbol adjustment
National standard style section symbol: The start and end positions of the section symbol and the turning position of the section symbol are drawn with thick and short lines on the view, and the connecting parts are drawn with dashed lines.
The adjustments in SOLIDWORKS are as follows:
If the attribute belongs to the Document Attribute, it can only be saved in a specific template, so you need to open the drawing template to modify the attribute when adjusting the attribute.
First of all, you need to open [Options] / [Document Properties] / [View] / [Section View] / [Line Style] of SOLIDWORKS, and select the appropriate section symbol.
The generation effect is shown in the figure: the specifications required by the national standard can be realized.
1. If the attribute belongs to [Document Attributes], it can only be saved in a specific template, so when adjusting the attribute, you need to open the drawing template to modify the attribute. First of all, you need to open [Options]/[Document Properties]/[Line Style]/[New] of SOLIDWORKS, and you can make custom line styles;
2. Define the name of the new line style;
3. Define the formatting key code of the new line;
Take A, 1, -1, 0.5, -0.5 as examples:
1) The difference between A and B parameters is that A parameter represents that both ends of the line are not bold, and B parameter represents that both ends of the line are bold, as shown in the figure:
A-parameter linetype
B. Parameter line type
2) 1,1,0.5,-0.5 represents a linear two-segment line segment, 1,-1 and 0.5,-0.5 two groups, taking 1,-1 as an example, a positive value of 1 indicates the length of the line segment, and a negative value of 1 indicates the direct gap between the line segment and the line segment, such as the gap between the dotted line or the dashed line. If you need to represent a solid line, you don't need a negative value, you can express A, 12 like this.
The above is the specific method of adjusting the existing cutting symbols of SOLIDWORKS and the cutting symbols of the national standard style, and you are welcome to interact and exchange more experience in the comment area.