When using a gas stove, some friends may experience the problem of not being able to light the flame, even if they see the electric spark flickering. Others may find that the flame goes out as soon as they let go.
Today I will teach you a simple method, no need to remove the gas stove, and no need to replace any parts, to solve this problem perfectly, and save 100 yuan in maintenance costs. With just a piece of waste paper and a scrap pen, you can easily fix it.
This method can help you save at least 100 yuan in maintenance costs, so let's take a look.
In the first case, there is no electric spark flickering and no sound of ignition when the gas stove is ignited. At this time, it is necessary to check whether the battery of the gas stove is dead. If the gas stove cannot be powered on because the battery is dead, simply replace the battery with a new one.
It should be noted that when replacing the battery, sometimes the yellow protective cover on the fire battery will be missed, resulting in the gas stove not being able to turn on the power to ignite.
In the second case, if the gas stove has a sparkling sound but no electric spark flickering. The ignition pin of the gas stove needs to be checked for water, oil, or dirt. These impurities covering the ignition needle can cause the ignition needle to fail to discharge.
The solution is to cut a small part of the sandpaper and make a small cylinder from a waste pen, and then put the sandpaper on the ignition needle and rotate it to remove impurities from the ignition needle.
In the third case, the gas stove has a sparkling sound and an electric spark flickering, but it does not catch fire. At this time, it is necessary to check whether the fire hole in the center of the gas stove is blocked, and you can use a toothpick or thin wire to penetrate the fire hole.
Also, make sure that the air outlet of the center small fire cover is aligned with the ignition needle, and check that the damper switch under the bottom of the gas stove is properly adjusted. If the damper switch is too large or too small, it will make it difficult for the gas stove to ignite.
In the fourth case, the gas stove has a sparkling sound and electric sparks flickering, but it does not catch fire. It is also impossible to ignite with a lighter. When encountering this situation, the first thing to check is whether the gas valve is open normally and whether the gas supply is normal. At the same time, it is also necessary to check whether the batteries of the gas meter and gas stove have electricity.
In addition, during daily cleaning, it is possible to accidentally loosen the nut under the gas hob knob, which is both a sealing ring and a fixing nut.
Loose nuts will cause the gas to not be discharged correctly when pressing the switch knob, resulting in the gas stove not being able to ignite.
The solution is to tighten the nut or stuff a ball of waste paper in the switch knob cap to raise the nut.
In the fifth case, the gas stove can ignite but turn off as soon as you let go. At this time, it is necessary to check whether the flame of the gas stove can burn normally to the induction device. If the fire hole of the small fire cover in the center is blocked or the damper switch is not well debugged, the flame will not be able to burn the induction device.
If the flame can reach the sensor normally, it is necessary to carefully observe the sensor for carbon, water or dirt. You can still use the old pen disposal sensor device to solve the problem.
If the above methods still don't solve your gas stove problem, it's not too late to find a repairer.
如果您觉得有用，别忘了点一下右下角收藏和点赞，也点一下左下角分享按钮，把它转发分享给身边的家人朋友，你的分享可以帮助到更多有需求的人哦。