Recently, the revelations about the iPhone 14 have become more and more intensive.
As various news gradually surfaced, we also basically understood the general appearance of the iPhone 14.
According to the previous news from the outside world, compared with the previous generation of models, the iPhone 14 will make great changes in appearance.
Among them, the iPhone 14 Pro model will abandon the bangs screen design that has been used for many years and use a new "exclamation point" shaped punch screen design.
Sources revealed that the Face ID component and camera will be hidden in two holes of different sizes, increasing the screen ratio.
At the same time, in order to better adapt to this design, the screen size of the iPhone 14 Pro model will be stretched, while the width will be slightly narrowed.
At present, this new punching screen design is basically stable.
Just now, foreign media 91mobiles exposed a set of CAD design drawings of the iPhone 14 Pro model, further confirming this design.
91mobiles said the design was based on CAD industrial drawings of the iPhone 14 Pro model in the Apple factory, which is highly reliable.
Judging from the design drawings, the front of the iPhone 14 Pro adopts an "exclamation point" shaped punching screen design, and the circular hole is located on the right side, which is basically the same as the previous news.
At the same time, the bottom edge of the iPhone 14 Pro has a speaker grille, microphone and lightning charging interface, all of which are some designs that we are very familiar with.
The iPhone 14 Pro has a basically identical design to the iPhone 13 Pro, with a huge square module that accommodates three camera assemblies, an LED flash, a microphone, and a LiDAR sensor.
It is worth mentioning that from the back of the design drawing, the rear camera module of the iPhone 14 remains convex, which also overturns the rumor that the camera will be flattened.
In addition, the overall size of the camera module has been improved, compared to the iPhone 13 Pro, the iPhone 14 Pro's camera module is closer to the frame.
This means that the iPhone 14 Pro will improve in image performance.
Many small partners may not understand the CAD design of the new iPhone, here is a small fruit for everyone to popularize science.
According to the convention, before the launch of the new iPhone, accessory manufacturers will obtain CAD drawings and other information from Apple's supply chain, which are usually the basis for mass production of iPhones.
Next, the accessory manufacturer will produce a model of the new iPhone based on the drawing information.
So every year before the release of the new iPhone, we can see the exposure of the CAD drawings, and then the news of the organic mold will flow out.
From the experience of previous years, the news from the new iPhone CAD drawings is basically reliable.
Judging from the iPhone 14 CAD design drawings exposed by this group, the appearance of the iPhone 14 Pro model can be basically determined.
This means that the iPhone 14 standard version and pro version model, which will be released this year, will have a big difference in appearance.
As for whether this change is good or bad, everyone has a different opinion.
According to the previous news from the outside world, the punch screen design will be first adopted on the iPhone 14 Pro model, and then extended to the entire series of iPhone 15 models.
This may be the design that will be used on iPhones in the next few years.
What do you think of this design, welcome to express your opinion in the comments section.