What is the method of installing the JS-2-80 shock absorber in a centrifugal water pump?
According to the installation site requirements of the pump JS-2-80 shock absorber and the corresponding industry specifications, the manufacturer today gives you a brief introduction to the installation method and the relevant professional skills!
1.JS-2-80 shock absorber components should be symmetrically laid out according to the key centerline of centrifugal water pump diesel generator, and the spatial layout can be clockwise or reversed.
2.JS-2-80 shock absorber When the suspension components of the machine and equipment select six support points, four of them are laid out in more than four of the ductile blocks or steel frame structures, and the other two should be set on the long architecture network, and adjust their components to make the suspension components as consistent as possible.
3. Column type centrifugal water pump JS-2-80 shock absorber generator set suspension equipment, generally do not need to be bonded or fixed with the ground, plastic block or steel frame structure.
4. When the column type centrifugal water pump diesel generator suspension installation applies JS-2-80 shock absorber, the steel frame should be set under the base of the centrifugal water pump diesel generator, and the steel frame should be installed with steel reinforcement lap length; the steel frame cannot be fixed with screw foot screws (with lock nut). Set the road surface screws, cross the road surface screws, fix the JS-2-80 shock absorber to the road surface or wooden floor, and then cross the wooden floor.
5.JS-2-80 The architecture line of the shock absorber cannot exceed the structure line of the ductile block, and the total load-bearing area of the steel frame structure shall not be less than the total load-bearing area at the top of the component.
6.JS-2-80 shock absorber reasonable layout in a single layer, if the output power ratio can not meet the regulations, you can two layers in series reasonable layout, but the cumulative number of superimposed layers can not exceed five layers, each layer of shock absorbing pads in series arrangement, specifications and models, the number of pieces, floor space and rubber hardness should be consistent.
7. Protective layer pads and carbon steel plates should be bonded with strong glue. The total floor plan specification model of the hot-dip galvanized sheet should be 10 mm larger than the two sides. It is superimposed and fused with the impression of the upper and lower layers of hot-dip galvanized sheet bonding.
8.JS-2-80 shock absorber before construction and assembly, should be checked immediately, installation should make the data format of the shock absorber electronic device smaller deformation can not exceed the larger standard value.
9. When installing a lifting diesel generator, the ground of the fulcrum of the installation of the lifting diesel generator should be flat and the bearing capacity should be sufficient.
10. The suspension components of diesel generators should avoid touching acids, alkalis and organic chemical saturated solutions.