juniper路由器配置1

<b></b>

<b>1， </b><b>增加端口配置模闆</b>

（1）需要子接口的端口配置

set interfaces fe-2/0/1 vlan-tagging              ――――在配置接口啟用封裝VLAN

set interfaces fe-2/0/1 unit 424 vlan-id 424       ―――――配置子接口，VLAN 424

set interfaces fe-2/0/1 unit 424 family inet address 192.168.254.146/30  ――配置子接口位址

（2）無需子接口配置

set interfaces fe-2/0/23 unit 0 family inet address 222.60.11.154/29   ――直接配置位址

（3）E1口配置

set interfaces e1-3/0/0 encapsulation ppp 封裝鍊路類型，包含PPP,HDLC，根據實際情況配置

set interfaces e1-3/0/0 e1-options framing unframed 封裝幀格式，參數包含unframed,g704, g704-no-crc4

set interfaces e1-3/0/0 unit 0 family inet address 192.168.1.126/30 配置位址

（4）CE1配置

set interfaces ce1-4/0/0 clocking external

set interfaces ce1-4/0/0 e1-options framing g704-no-crc4

set interfaces ce1-4/0/0 partition 1 timeslots 1-31    ――――設定信道1及時隙1－31

set interfaces ce1-4/0/0 partition 1 interface-type ds  ――――子接口類型DS

set interfaces ds-4/0/0:1 encapsulation ppp         ―――――配置子接口封裝ppp

set interfaces ds-4/0/0:1 unit 0 family inet filter input NYYH

set interfaces ds-4/0/0:1 unit 0 family inet address 10.238.173.197/30  ――――配置位址

（5）政策配置

set firewall filter shigonganjuMAS term 1 from source-address 10.238.173.180/30

set firewall filter shigonganjuMAS term 1 then accept

set firewall filter shigonganjuMAS term 2 from source-address 10.238.173.0/24

set firewall filter shigonganjuMAS term 2 from source-address 10.238.179.0/24

set firewall filter shigonganjuMAS term 2 then discard

set firewall filter shigonganjuMAS term 3 then accept

set interfaces fe-2/0/0 unit 44 family inet filter input jiaotongyinhangduanxin―――将政策應用至子接口。

日常維護指令

1   檢視序列号show chassis hardware

2   檢視硬體show chassis hardware

3   檢視軟體版本show version

4   檢視CPU  show chassis routing-engine

5   ping指令

ping 192.168.1.254 rapid    #快速ping位址  

6   檢視裝置告警資訊 show chassis alarms 

7   檢視詳細的硬體溫度及狀态資訊 show chassis environment 

8   收集CASE需要的資訊request support information

     本文轉自小俠唐在飛 51CTO部落格，原文連結：http://blog.51cto.com/xiaoxia/163138，如需轉載請自行聯系原作者