juniper路由器配置1

<b></b>

<b>1， </b><b>增加端口配置模板</b>

（1）需要子接口的端口配置

set interfaces fe-2/0/1 vlan-tagging              ――――在配置接口启用封装VLAN

set interfaces fe-2/0/1 unit 424 vlan-id 424       ―――――配置子接口，VLAN 424

set interfaces fe-2/0/1 unit 424 family inet address 192.168.254.146/30  ――配置子接口地址

（2）无需子接口配置

set interfaces fe-2/0/23 unit 0 family inet address 222.60.11.154/29   ――直接配置地址

（3）E1口配置

set interfaces e1-3/0/0 encapsulation ppp 封装链路类型，包含PPP,HDLC，根据实际情况配置

set interfaces e1-3/0/0 e1-options framing unframed 封装帧格式，参数包含unframed,g704, g704-no-crc4

set interfaces e1-3/0/0 unit 0 family inet address 192.168.1.126/30 配置地址

（4）CE1配置

set interfaces ce1-4/0/0 clocking external

set interfaces ce1-4/0/0 e1-options framing g704-no-crc4

set interfaces ce1-4/0/0 partition 1 timeslots 1-31    ――――设置信道1及时隙1－31

set interfaces ce1-4/0/0 partition 1 interface-type ds  ――――子接口类型DS

set interfaces ds-4/0/0:1 encapsulation ppp         ―――――配置子接口封装ppp

set interfaces ds-4/0/0:1 unit 0 family inet filter input NYYH

set interfaces ds-4/0/0:1 unit 0 family inet address 10.238.173.197/30  ――――配置地址

（5）策略配置

set firewall filter shigonganjuMAS term 1 from source-address 10.238.173.180/30

set firewall filter shigonganjuMAS term 1 then accept

set firewall filter shigonganjuMAS term 2 from source-address 10.238.173.0/24

set firewall filter shigonganjuMAS term 2 from source-address 10.238.179.0/24

set firewall filter shigonganjuMAS term 2 then discard

set firewall filter shigonganjuMAS term 3 then accept

set interfaces fe-2/0/0 unit 44 family inet filter input jiaotongyinhangduanxin―――将策略应用至子接口。

日常维护命令

1   查看序列号show chassis hardware

2   查看硬件show chassis hardware

3   查看软件版本show version

4   查看CPU  show chassis routing-engine

5   ping命令

ping 192.168.1.254 rapid    #快速ping地址  

6   查看设备告警信息 show chassis alarms 

7   查看详细的硬件温度及状态信息 show chassis environment 

8   收集CASE需要的信息request support information

     本文转自小侠唐在飞 51CTO博客，原文链接：http://blog.51cto.com/xiaoxia/163138，如需转载请自行联系原作者