分享兴趣，传播快乐，增长见闻，留下美好！
亲爱的您，这里是LearningYard新学苑。
今天小编为你带来
畅享聊：SolidWorks学习（14）
欢迎您的访问！
Share interests, spread happiness, increase knowledge, and leave beautiful!
Dear you, this is LearningYard Academy.
Today, the editor brings you
Changxiang Chat:SolidWorks Learning (14)
welcome your visit!
前两期我们已经画好了电风扇的前罩和后罩，那么今天我们将绘制它的支架，我们还是打开一个新的零件图，然后在上视基准面上进行草图绘制，绘制好如下图所示的草图形状，然后选择前视基准面，绘制如下图的草图，右视基准面草图绘制如下。使用投影曲线，得到一条新的曲线，在设置基准面距离右基准面85mm，然后绘制草图。
We have already drawn the front and rear covers of the electric fan in the first two issues. Today, we will draw its bracket. We will still open a new part drawing and sketch on the upper reference plane. Draw the sketch shape as shown in the figure below, then select the front reference plane and draw the sketch as shown in the figure below. The sketch on the right reference plane is as follows. Use a projection curve to obtain a new curve, set the distance between the reference plane and the right reference plane to 85mm, and then draw a sketch.
接着完成草图后，点击特征，选择拉伸凸台，将刚画好的草图进行拉伸，深度给定为2mm。完成拉伸后，在对其进行倒圆角，圆角参数为0.5mm。然后进行扫描，将线扫描成柱体。扫描直径为5mm，完成扫描，接着如下图设置参考面，在此参考面上进行草图绘制，绘制好后如下图。然后点击放样凸台，以刚画的草图中的两条线作为引导线进行放样。
After completing the sketch, click on the feature, select the extruded protrusion, and stretch the just drawn sketch to a depth of 2mm. After completing the stretching, fillet it with a fillet parameter of 0.5mm. Then perform a scan and scan the lines into columns. Scan with a diameter of 5mm, complete the scan, then set the reference surface as shown in the figure below, and sketch on this reference surface. After drawing, it is shown in the figure below. Then click on the lofting boss and use the two lines from the just drawn sketch as guide lines for the lofting.
接着选择镜向，镜向基准面选择右基准面，选择要镜向的实体，将整个模型进行选择，然后点击确定。
Next, select the mirror orientation, mirror orientation reference plane, select the right reference plane, select the entity to mirror orientation, select the entire model, and then click OK.
今天的分享就到这里了。
如果您对今天的文章有独特的想法，
欢迎给我们留言，
让我们相约明天，
祝您今天过得开心快乐！
That's it for today's sharing.
If you have a unique idea about today’s article,
Welcome to leave us a message,
Let us meet tomorrow,
I wish you a nice day today!
本文由learningyard新学苑原创，如有侵权，请联系我们。
部分内容参考于bilibili，百度
翻译来源：通义千问
文字排版｜calm
审核｜歪歪