Share interests, spread happiness, increase knowledge, and leave a good stay!
Dear you, this is LearningYard.
Today, I bring you this
Enjoy Chat: Learning with SolidWorks (14)
Welcome to visit!
Share interests, spread happiness, increase knowledge, and leave beautiful!
Dear you, this is LearningYard Academy.
Today, the editor brings you
Changxiang Chat:SolidWorks Learning (14)
welcome your visit!
In the first two phases, we have drawn the front cover and rear cover of the electric fan, so today we will draw its bracket, we will still open a new part drawing, and then sketch on the top datum, draw the sketch shape as shown in the figure below, and then select the front datum and draw the sketch as shown below, and the sketch of the right datum is drawn as follows. Using the projection curve, get a new curve, set the datum 85mm away from the right datum, and then draw a sketch.
We have already drawn the front and rear covers of the electric fan in the first two issues. Today, we will draw its bracket. We will still open a new part drawing and sketch on the upper reference plane. Draw the sketch shape as shown in the figure below, then select the front reference plane and draw the sketch as shown in the figure below. The sketch on the right reference plane is as follows. Use a projection curve to obtain a new curve, set the distance between the reference plane and the right reference plane to 85mm, and then draw a sketch.
Then, after completing the sketch, click on the feature, select the extrusion boss, and stretch the sketch you just drew to a depth of 2mm. After the stretching is completed, it is rounded with a fillet parameter of 0.5mm. A sweep is then made, and the line is scanned into a cylinder. The scanning diameter is 5mm, complete the scanning, and then set the reference surface as shown below, sketch on this reference surface, and draw it as shown below. Then click the loft boss to stake out the two lines from the sketch you just drew as guide lines.
After completing the sketch, click on the feature, select the extruded protrusion, and stretch the just drawn sketch to a depth of 2mm. After completing the stretching, fillet it with a fillet parameter of 0.5mm. Then perform a scan and scan the lines into columns. Scan with a diameter of 5mm, complete the scan, then set the reference surface as shown in the figure below, and sketch on this reference surface. After drawing, it is shown in the figure below. Then click on the lofting boss and use the two lines from the just drawn sketch as guide lines for the lofting.
Then select the mirror direction, select the right plane for the mirror plane, select the entity you want to mirror, select the entire model, and click OK.
Next, select the mirror orientation, mirror orientation reference plane, select the right reference plane, select the entity to mirror orientation, select the entire model, and then click OK.
That's all for today's sharing.
If you have a unique idea for today's article,
Welcome to leave us a message,
Let's meet tomorrow,
Have a great day!
That's it for today's sharing.
If you have a unique idea about today’s article,
Welcome to leave us a message,
Let us meet tomorrow,
I wish you a nice day today!
This article was originally written by LearningYard, if there is any infringement, please contact us.
Part of the content is referenced from bilibili, Baidu
Translation source: Tongyi Qianwen
Typography|calm
Audit|crooked