Share interests, spread happiness, increase knowledge, and leave a good stay!
Dear you, this is LearningYard.
Today, I bring you this
Enjoy Chat: SolidWorks Learning(17)
Welcome to visit!
Share interests, spread happiness, increase knowledge, and leave beautiful!
Dear you, this is LearningYard Academy.
Today, the editor brings you
Changxiang Chat:SolidWorks Learning (17)
welcome your visit!
In this issue, we use SOLIDWORKS to complete the fan motor base and anti-slip bushing, first sketch on the front view datum, draw the sketch style as shown below, and then select the equidistant solid, so as to draw the thin wall width, and then set the corresponding size, after completion, you can select the rotating boss to get the rotating body below.
In this issue, we used SolidWorks to complete the fan motor base and anti slip lining. Firstly, we sketched on the front reference plane, drawing the sketch style as shown in the figure below. Then, we selected equidistant entities to draw the thin-walled width, and set the corresponding dimensions. After completion, we can select the rotating boss to obtain the rotating body below.
Then draw a circle on the end face, use a circumferential array to get six circles, and use extrusion to get six holes. Then draw a circular sketch on the surface shown in the figure below, then perform a circumferential array to get three circular sketches, click to complete the sketch, and then click on the feature to stretch the circle to the next plane.
Then sketch a circle on the end face, use a circular array to obtain six circles, and use extrusion to cut off six circular holes. Next, draw a circular sketch on the surface shown in the figure below, then perform a circular array to obtain three circular sketches. Click to complete the sketch, then click on the feature to stretch the drawn circle to the next plane.
After completion, then on the plane just now, draw the campus with the center of the sketch circle just drawn as the center of the circle, with a radius of 2.5mm, and then use the same circumferential array, use stretch excision, and set the cutting depth to 8mm, and then finish as shown in the following figure. Then round and chamfer, and finally make adjustments to the appearance to save.
After completion, draw the campus on the plane just now with the center of the sketch circle as the center, with a radius of 2.5mm. Then, use the same circular array and stretch to cut, with a cutting depth of 8mm. After completion, it will look like the following image. Then perform rounding and chamfering, and finally adjust the appearance to save.
Then draw the anti-slip bushing, this part is very simple, first draw two circles on the front datum, the diameter of the compound is 10mm, and the diameter of the small circle we set to 4mm. The boss is then stretched to a length of 5 mm. Then round and chamfer are carried out, both with a parameter of 0.2mm.
Then draw the anti slip lining. This part is very simple. First, draw two circles on the front reference plane, with a diameter of 10mm for the large courtyard and 4mm for the small circle. Then perform protrusion stretching, with a stretching length of 5mm. Then perform rounding and chamfering, with parameters of 0.2mm.
That's all for today's sharing.
If you have a unique idea for today's article,
Welcome to leave us a message,
Let's meet tomorrow,
Have a great day!
That's it for today's sharing.
If you have a unique idea about today’s article,
Welcome to leave us a message,
Let us meet tomorrow,
I wish you a nice day today!
This article was originally written by LearningYard, if there is any infringement, please contact us.
Part of the content is referenced from bilibili, Baidu
Translation source: Tongyi Qianwen
Text & Typography |
Audit|crooked