You need to put the entire square on the side of the desktop computer mainframe
The cover plate is taken down,
The DVD drive must not have convex on either narrow side
The screw (shown in Figures 5 and 6).
The front of the desktop computer has a black decorative cover,
There are three buckles on the side, and the three buckles are wrenched open.
You can take down the entire decorative cover (as shown in Fig. 2, 3 and
Figure 4), and then slowly release the optical drive from the front
Location of the optical drive (As shown in Figure 7, the optical drive must.)
Install from the front, if you can't put light from inside the console
Drive) (The outlet of the optical drive is facing you, and the key is opened
Off also towards himself), and then with a screw
Secure the optical drive to the side housing of the main unit (Figure 9
shown).
There are two sockets on the back of the optical drive, both facing themselves,
From left to right, the first is a wider socket marker
Note: SATA POWER (P15 and P1) (CD-ROM drive
power cord connector),
The second narrower socket is labeled: SATA DATA
(S7 and S1) (optical drive data cable socket).
The first wider socket of the optical drive plugs into the SSD
of any flat power cord (there are three flat in total
plug, as shown in Figure XIII),
The second narrower socket of the optical drive inserts flat data
line, the other end of this flat data cable is inserted into the main
Scarlet socket of the plate (as shown in Figure XIV).
Figure 1
Figure II
Figure III
Figure IV
Figure V
Figure VI
Figure VII
Figure VIII
Figure IX
Figure X
Figure XI
Figure XII
Figure XIII
Figure XIV