Hello everyone, I'm a waveguide terminator.
Recently, I plan to install a 12700K+3080Ti machine, and it is expected that in addition to the unique display, I also want to put on two capture cards, so I must go to the ATX board. The power supply chose the white version of the POLAR platinum module of bone jia, so the chassis is also on the white version of Ha.
My needs are still a bit polarized, either the small host meets the basic needs, or the ATX+ tower chassis maintains some internal space and scalability. More love to toss, no way, the air duct and wiring of the large chassis are also easier to get.
The Bone GaGa Shadow Warrior X7 can accommodate the largest plate of THEX, but in terms of my purpose, ATX is enough.
This bezel, conventionally designed, can be fitted with a 120mm chassis fan.
The bottom stops can be disassembled independently, and one more piece is given in the accessory bag. In addition, this chassis also supports the vertical installation of graphics cards, you can get a line yourself, after all, the length and weight of the graphics card are now getting bigger and bigger. However, this will obscure other PCIe boards, so it is not neat for the time being. If the graphics card is not installed in this position above the power supply, you can add 2 more 120 fans.
The power supply is lowered and the bottom of the chassis is equipped with a dust mesh. If the chassis is placed directly on the ground, it is possible to become a vacuum cleaner, which I have cleaned once before, so the dust net is necessary.
The power supply shock pad can effectively absorb the vibration and noise of some power supplies, which is still needed by users who are sensitive to this aspect.
There are also 2 3.5-inch hard disk positions at the bottom, one at the bottom, one on the top lock, if it is a 2.5-inch disk, in addition to here, there are many places on the chassis that can be installed.
The chassis backplane part directly integrates an RGB fan hub, after all, there are more and more fans now, and the opening on the motherboard is definitely not enough. Next to it is the installation bit of the 2.5-inch hard drive.
Because I am not a wiring expert, I still pay more attention to the convenience of chassis routing. Bone Ga Shadow Warrior X7 back plate here to give a lot of thread holes, and then come with two magic cable ties, line management is still very convenient.
The top panel supports 120x3 or 140x2 fan mounting, and of course also supports 360 cold discharges up to 396mm. Magnetic dust net, very convenient to clean. 2 USB3.0, 1 USB 2.0 extension, the restart key is canceled, and the small button is the light control key.
The front panel still supports a set of 120x3 or 140x2 fans, which is really enough for the fan position.
In terms of side panels, the details can still be seen, and the corners are made of a sleek chamfer design to prevent cutting hands.
For the tempered glass side, it is very important to protect the four corners, this thing is like Rupert's tears, the four corners are its weaknesses, and the Shadow Warrior X7 is also directly protected by metal blocks.
In terms of accessories, two stops, several wire ties, and a large package of screws were given. Speaking of screws, there should be a lot left in the machine after installing several times, but there is only one model that I think still needs to pay attention to, that is, the screws of M.2, which basically only has one motherboard, and a very small number of NVMe solid states will send one.
Since the motherboard has not yet arrived, see here first, and then the white chassis + water cooling + power supply will be installed and then look at the whole. Water-cooled is also the White Version of Poseidon 360 of Bone Ga.
Thank you for watching, like friends to help point out a little attention and like it, we will see you in the next issue.
Bone Ga Shadow Warrior X7 Computer Main Chassis Tower Side ViewEr Support 360 Water Cooled Polar White ¥399 Purchase