After my KYMCO CV3 was delivered, because the original half helmet could not put the space under the toilet, I wanted to buy a 3/4 helmet before the rear box shelf was on the market. Purchased on 2022/04/19 evening. The owner was nice and patient and asked me to try a few helmet-type space. The SO-7E of SOL was finally chosen, but fortunately, because I was wearing a helmet to buy, I only wore it this morning when I was ready to go out at 04/20. As a result, when the silver label sticker was torn off, unnatural marks were found, and when I touched it, it looked like the shiny paint was broken.
Immediately take a close look at the phone, it is really bright paint broken.
The original sticker is long like this (silver product label sticker)
This is the difference between the original location of the paste and the date of the water taken because the reader wants to see the relative position. Before tearing in the morning, I didn't leave a photo record, because I didn't expect the new look of SOL to paint the quality so..... difference
Not sure if it's a defect from the factory and covered with stickers? Or is the sticker sticky too strong to pull? Or is it that the pull resistance of the original new helmet coating is insufficient? Because the helmet is not expensive, there is a return to the store at night to reflect with the boss, and there is no after-sales service that requires a warranty. Touch your nose and admit it. I want to say that I use transparent nail polish to light it up and avoid getting bigger and bigger.
As a result, I found a new bubble next to it, then I must be a new product flaw, a problem with the coating. At the beginning, I saw that SOL had the MIT seal and wanted to say that the quality should be no problem. I didn't expect such a long-established label, even a basic livery, to be so unbearable. Even if this helmet does not have any wind cutting sounds, helmet type and paint pattern is OK. But this basic coating has quality problems (or quality control problems) and everything else is in vain. Of course, I'm not going to go back to the concave warranty, buy it and wear it. But in the future SOL I personally will not buy this product again, sincerely do not advise to buy, if there are riders willing to buy SOL helmets, it is recommended to tear open the sticker you want to remove at the store site to confirm, so that if you have not left the store, you can also confirm whether there is a flaw.