What is your WiFi speed? If it feels slow, do you have a reason for it?
We all know that now the home network will basically use light cats, but there are two modes of this light cat that can be used, you know?
The two modes are Router mode and bridging mode.
What is Router mode? It is accessed to the Internet through the WAN port, the function is the same as that of ordinary wireless routers, and its characteristics are the need to configure PPPoE dial-up settings and broadband dial-up Internet access. The bridging mode is a basic setting of the home network, which is also more important, which can reduce the network performance bottleneck caused by the optical cat problem, home network failure, etc.
Compared with the two, the bridging mode will be better, Xiaobian recommends that after handling broadband services, the optical cat is set to the bridging mode first, and then the connection and debugging of other network devices are carried out.
If you are using routing mode non-bridged mode, do you know how to modify it? Next, Xiaobian will talk to you in detail about the operation steps.
The first thing to do is to obtain the password of the super administrator account of Guangmao, which is the most critical step. It is recommended to contact the installation master of The Light Cat or the broadband customer service phone to ask for the super administrator password, which is the easiest way.
Then it is necessary to obtain the dialing account and password of Guangmao, and you need to contact the broadband operator, and the operator will check the information for the broadband, and then reset the password to inform us of the dialed account and password.
With these two account passwords, we can use the super administrator to log in to the management interface of Guangmao.
After logging in to the optical cat management interface, switch to [Network], click [Network Settings] - [Network Connection], select [2_INTERNET_R_VID_41] for connection name, select [Bridge] for connection mode, and finally click [Save].
Next, you need to close the DHCP service of Guangmao, click [Network] - [User Side Management] - [IPV4 Settings], then cancel the DHCP Server check, and finally click [Save].
The final step is to use a router to dial. In the router management background, change the Internet access mode of the WAN port to PPPOE. If it is a light cat dial, the way to access the Internet here is DHCP. Then enter the broadband account number and password, and save it.
The process is a bit complicated, you can carefully study and then operate ~ ~