Today, I would like to introduce you to a very practical small function in the label making software, which is the setting of "edge". The technical term is called the edge line, and it also has another name called the cutting line, which is to facilitate the line used to indicate the cutting part when cutting the label. Let's take a look at the specific operation method of setting edges in label making software.
After the labels that need to be made in the software are completed, click on the "Document Settings" canvas of the software, and the edges (the edges supported in the label maker software are cut lines, crop points, outline lines, quadrangular lines, and crosshairs) and then look at the effects of these edges.
1) Trim line - set the edge line to "cut line" in the document settings, set the color, thickness, length, and offset of the article, click to confirm, note that the effect of setting the trim line can not be seen in the white canvas interface of the software, you need to click the print preview, and you can see the effect of setting the edge.
2) Trim Point - When the edge is set as the trim point, the trimmed edge looks like a dotted trim line.
3) Contour - When setting the edge line as the contour line, you can only select the color and group of the contour line, and other parameters can not be selected.
4) Four corners - When the edges are set to four corners, you can see that the four corners of the whole label show the "L" shaped cut line.
5) Crosshairs - When you set the edge line as a crosshair, you can see in the print preview that the position of the edge line in the label is "+".
The above is the specific method and effect of setting the edge in the label making software, and you can follow the method in the article to set it up if you need it.