Process and Standardized Management Manual for Property Companies - Real Estate

Process and Standardized Management Manual for Property Companies - Real Estate

Please follow the instructions at the end of this article to obtain a PDF document

The first part is to optimize the process

The second part is to use institutional norms

Part 3 Execution with tools

Part 4 Demonstrate with examples

8. Residential (building) power equipment plane, distribution system diagram. Chapter 3 Specifications for the operation of substation and distribution rooms

Article 8 Regardless of whether the high-voltage equipment is live or not, the personnel on duty shall not move or work over the fence alone. If it is necessary to remove the fence, a guardian must be present and comply with the safe distance when the equipment is not powered off.

Article 9 Specifications for patrol work.

1. When you need to inspect or operate outdoor high-voltage equipment during thunderstorms, you should wear insulated shoes, and you should not be close to lightning arresters and lightning rods.

2. When entering and exiting the high-voltage room to inspect the power distribution device, the door must be locked. Article 10 Operation specifications for power outages and power transmission and reversing.

1. Contact the power supply unit or the owner to stop and send the power to reverse the operation, the person in charge of the duty must check that it is correct, and make a record of the operation content and the name of the contact person.

2. The operation of power failure must be operated in the order of oil switch (or load switch, etc.), load side knife switch, and bus side knife switch.

3. The reverse operation on the large-capacity low-voltage main plate of high-voltage equipment must be performed by two people, and one person who is more familiar with the equipment serves as a guardian. Oil switches and knife switches that are remotely controlled or operated by a partition wall (and oil switches have an interlocking device) can be operated by a single person.

4. When using an insulating rod to pull the high-voltage knife switch or pull the high-voltage knife switch and the oil switch through the transmission mechanism, insulating gloves should also be worn.

5. It is forbidden to engage in the reverse gate work in thunderstorm weather.