In the decoration, there are the most routines for the whole house customization, and it is a pit if you don't pay attention to it, but it is undeniable that the whole house customization does save you a lot of trouble, and the style is also unified, and there is really nothing to say about the appearance!
Today, let's talk about the whole house customization, as long as you figure out these key points, you have to weigh it if you want to pit it~
——Environmental protection of the plate——
In the whole house customization, the materials of the board are also varied, but what kind of board should we choose?
Among these boards, it is recommended to choose multi-layer solid wood boards, which are moisture-proof and durable, and the key is high environmental protection coefficient.
The least recommended is to choose particle board and MDF, although the price may be cheap, but as a cabinet or wardrobe is not moisture-proof and not durable!
——Thickness——
The material of the plate is the focus of our attention, but the thickness of the plate should not be underestimated! So thick plate is the best? Is the thicker the better?
The thickness of the plate is roughly 15, 18, 25, 36 mm, etc., under normal circumstances, most of the cabinets are made of 18 mm thick plates, and at the same time, the back plate is 9 mm thick.
There are also businesses that cut corners and will use a 5 mm thick back plate, which is not very authentic! This kind of plate is too thin, and it is easy to deform in the later stage, reducing the service life of the cabinet.
——Edge banding method——
When doing whole-house customization, there needs to be a process of edge banding, don't underestimate an edge banding, but there are three ways, namely: laser, PUR and EVA edge banding.
Among them, laser edge banding is the most ideal one, but most factories can not be satisfied, followed by PUR edge banding, which is also the most commonly used means on the market, the worst is EVA edge banding, not only the workmanship is slightly rough, the quality is also relatively poor!
Therefore, it is best to choose the first two, and the last one is not recommended, even if it is cheaper!
——Hardware——
The hardware used in the cabinet must also be seen clearly, don't ignore its importance because of its subtlety! It is best to choose brand hardware, there is no big problem in the quality, such as: Blum, Hettich, Dinggu and so on are good hardware brands.
And be sure to discuss in advance, whether hardware accessories are included in the total cost, or to buy separately, these need to be understood in advance!
——Pricing method——
There are two pricing methods for whole house customization: unfolded area pricing and projection area pricing, due to the difference between the two pricing methods, the final price will also change!
Unfolded Area Valuation:
It is equivalent to spreading the cabinet to calculate the price, that is, to buy a plate are included in it, the process is more numerous, and it is easy to be more priced by the merchant, and finally as the owner of the house you are also very helpless, it is not good to calculate the total price, although the unit price is low, but it is easy to be more priced, not suitable!
Projection Area:
It is to multiply the length of the cabinet by the height, and then to the projection area on the wall, you can calculate what the price is, which already includes hardware accessories, which is more convenient, simple and clear!
(Picture invasion and deletion)