1. Five operation steps of low-temperature pyrolysis furnace:
1. First of all, open the feeding furnace door and fill in a part of the garbage (about 1/4 of the height of the furnace).
2. Close the furnace door and turn on the induced draft fan.
3. Turn on the burner and ignite according to the ignition instructions in the burner manual.
4. When the garbage in the incinerator is completely burned, turn on the secondary burner and ignite it according to the same steps as the first burning.
5. Open the observation hole of the combustion chamber to watch the garbage burning in the furnace and add garbage.
2. Five characteristics of low-temperature pyrolysis furnace:
1. It can handle a wide range of garbage, including industrial waste, domestic garbage, hospital waste, waste rubber tires, etc.
2. The combustion heat efficiency is high, even if the water content is very large, the combustion heat efficiency is more than 70%.
3. The operation and maintenance cost is low, due to the use of many special designs and a high level of automation control, there are few operating personnel (including ash removal and refilling, only one person is needed), and the maintenance workload is also less.
4. High reliability, the failure rate of this incinerator is very low, the annual operation is more than 7500 hours, and the general utilization rate can reach more than 95%.
5. The emission control level is high, and the secondary flue gas is recombusted, so that the flue gas has been fully treated, and the emissions meet the national emission standards after long-term testing.