laitimes

I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.

author:What is worth buying

This content comes from @What's worth buyingAPP, and the views only represent the author's own |Author: xiaomings

There is a large succulent flower pot at home, but the holes in the flower pot are too small, and it is difficult to grow succulents well. So I planned to give it a few bigger holes, use the original 2 kinds of drill bits at home, and buy another drill bit back. 3 different drill bits to punch holes in ceramic flower pots, and I will share with you 3 different drill bits for punching holes:

1 Green Forest Overlord Drill Bits

I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.
I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.

It's still easier to use when you start punching, but the more you go to the back, the slower it becomes, and you don't get a hole for more than ten minutes. The advantage is that it is easy to position, and it is not easy to break the ceramics or tiles, but it is very slow.

I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.
I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.

The advantage is that it is easy to locate, and the speed of punching is a little faster than that of Bawang drill bits, but it also takes more than ten minutes to punch a hole. The eccentric drill bit is not easy to break the ceramic or tile, and it is very easy to use if you try to drill holes in the tile.

3. Tile punching drill bits

I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.
I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.

This tile drill bit is not easy to locate, according to the video method of 45 degrees oblique is not very good, and then the electric drill is adjusted to low speed first oblique drilling, and then adjusted back to high-speed mode to drill a hole. But at the end of the time, I was careless, and I pressed down hard and cracked the pot.

I used three different drill bits to drill holes in the flower pot, and finally cracked the flower pot drill.

In the end, it is still easier to use eccentric drilling, but it is still relatively slow. In addition, remember not to press hard, otherwise it will be sad...

Read on