1. Foreword: 3D printing plexiglass light strip blessed high-value memory
Since its birth in 2003, Yinglax has just gone through a full 20 years of journey.
As the brand that pays the most attention to appearance, the Xingyao series has always been loved by players.
Recently, Yingchi Xingyao launched the 20th anniversary edition of Xingyao DDR5-7200 24GB memory, which may be the current memory with the highest appearance.
The 20th Anniversary Edition of the Shadow Run DDR5-7200 24GB memory is different in that it uses a 3D printed transparent material light guide strip, compared to the light guide strip of most of the memory is PC or EP material.
Of course, this memory is not only limited to its appearance, but also has good overclocking capabilities.
The 20th Anniversary Edition of the Galaxy DDR5-7200 24GB memory uses Hynix M-Die chips, and its overclocking potential is comparable to SK hynix's A-Die chips.
Even at frequencies up to 7200MHz, the memory timing is still suppressed at 36-46-46-116 CR2 at 1.4V.
The test platform is as follows
2. Picture appreciation: pure white super high value
White box with the word 20th in the middle, which is the 20th anniversary.
Unboxing.
Pure white color matching, the heat dissipation vest adopts a metal electrophoretic white process, the LOGO is made of silver embossing process, and the top is a 3D printed transparent material light guide strip, with the word SINCE2003 on the left, which is just 20 years now.
Disassemble the memory module.
Memory on one side, empty on the other side.
There are a total of 8 DDR5 DRAM ICs, which means that each one has a capacity of 3GB.
There are no memory particles on the other side.
The chip comes from SK hynix, with the number H5CGD8MGBDX021, which is SK hynix's current M-DIE particles.
Let's take a look at the lighting effect diagram of the machine:
3. Performance test: it can exceed 7800MHz
1. Memory bandwidth test
This is measured with the BIOS full default, the memory frequency is 4800MHz, the timing is 40-39-39-76 CR2, the read, write, and copy bandwidths of the memory are 76410MB/s, 68435MB/s, and 69384MB/s, respectively, and the memory latency is 87.3ns.
Directly enable XMP mode in the BIOS, let the Starlight DDR5-7200 24GB memory run at 7200MHz, the timing is 36-46-46-116 CR2, and the default voltage is 1.4V.
At this time, the read, write, and copy bandwidths of the memory are 106 GB/s, 91,306 MB/s, and 95,808 MB/s, respectively, an increase of 21-28%, and the latency is reduced to 70.3ns, a decrease of 17%.
2. Overclocking and stability test
Pressurize to 1.53V, relax the timing to 40-52-52-128 CR2, pull the memory frequency to 8000MHz, and optimize the small parameters to enter the system normally, but there will be a lot of errors in the Memtest stability test, and finally the error will be less after downclocking to 7800MHz.
At 7800MHz, the read speed is 119GB/s, the write speed is 101MB/s, and the latency is only 58.5ns.
At 1.53V, 7800MHz frequency, timing 40-52-52-128 CR2, using MemtestPro 4.3 to test stability after overclocking, a total of 58 minutes of testing, 134% progress, 0 errors.
It's just that the memory temperature is a little high, and if you try to use it with high load time, you need to do a good job of cooling the chassis and try to control the memory temperature below 75 degrees.
4. Summary: Meet your needs for performance and appearance
Most of the 32GB memory on the market is much worse than the 16GB memory in terms of timing and frequency, while the 24GB memory can not only ensure the memory capacity, but also have almost no difference from the 16GB in terms of performance, which can meet the pursuit of high-end gamers for capacity and performance.
In terms of performance, under the default XMP settings, the read bandwidth of the 20th Anniversary Edition Xingyao DDR5-7200 24GB memory exceeds 100GB/s, and the latency is 70ns.
As far as the test results are concerned, the memory not only works reliably at 7200MHz, but also has decent overclocking capabilities.
By increasing the voltage from the default 1.4V to 1.53V, the 20th Anniversary Edition of the Galaxy DDR5-7200 24GB memory can pass the Memtest stability test at 7800MHz, with a latency of only 58.5ns, which is comparable to high-frequency DDR4 memory.
In terms of appearance, the 20th Anniversary Edition of Yingchi Xingyao DDR5-7200 24GB memory uses a white vest and white PCB, especially the 3D printed transparent material light bar on its top can create a different lighting atmosphere from the previous light bar, which looks like a colorful and diffused light.
If you want to build a high-value console in the near future and want to experience powerful gaming performance, then you may wish to consider this 20th anniversary DDR5 24GB memory that can stabilize to 7800MHz.