Installation requirements for corn deep equipment high square flat screen

High square flat sieve as a kind of screening equipment, mainly with grain processing equipment, take corn processing as an example, corn after the equipment processing, grinding materials through the high square flat sieve sieve, and then separated from the qualified corn flour, but in the processing of different types of flour, the processing technology used is not the same, the installation requirements of the flat sieve are also different, the specific details are as follows.

　　First of all, when installing the high square flat screen, it is necessary to first determine the type of products produced by yourself, and select the installation of the equipment according to the product to achieve the effect you need.

　　Generally, the corn deep complete set of equipment is high square flat sieve, the beam is in the middle of the equipment sieve body, there are also individuals will be installed below, and the motor is mostly above the sieve body, and some will also be installed below.

　　Secondly, the flat screen must be started at complete standstill, when the entire corn deep equipment to stop, you need to stop the flat screen first, after the flat screen stops running, other accessories and equipment are out of material.

　　The number of sieve compartment separation bins of the high square flat screen is mostly the same, one of which is a three-compartment square sieve grid, and the other is a four-compartment narrow sieve grid, which can adapt to different flow and nature of the material, and carry out sieve on the sieve flat sieve, giving play to the advantages of the sieve area.

　　In addition, it is very important to do a good job in the correct operation and maintenance of the high square flat sieve, and for the maintenance of the flat sieve, the detection and adjustment work is an important part of the corn flour production process.

　　Corn deep equipment in the process of operation should pay attention to the movement of the sieve body, observe whether the four corners of the sieve body, the amplitude of the upper and lower is consistent, if the amplitude of the four corners is found to be unequal, should check whether the silo is blocked, whether the hanging device is normal; If the upper and lower amplitudes are not equal, after excluding the influencing factors such as blockage in the warehouse, the vertical position of the bias block needs to be checked during equipment maintenance.

　　Due to the large size of the high square flat sieve, the faulty start is likely to cause a large accident, once the equipment is running, it is difficult to troubleshoot the fault, so it is necessary to carefully check the hanging device of the sieve body, the warehouse door, the transmission mechanism, the inlet and outlet pipe connection tube and other parts before starting, and after preparation, the equipment can be started.

　　Learn more about corn processing equipment, corn deep processing machinery, corn processing machinery, corn deep processing equipment: www.hncljx.com