laitimes

Driving in the rain can't see the rearview mirror? Try these tricks!

For drivers, rain is a nuisance, because the windows and rearview mirrors are often full of water droplets, and the use of wipers is always not clean, making it difficult to see the traffic on the road.

How to maintain the clarity of the rearview mirror and window glass on rainy days, how to adjust the wiper to make the windshield clean, some of the following methods can be tried:

01

Use a special rain remover, spray on the window glass, and do it in one move!

Driving in the rain can't see the rearview mirror? Try these tricks!
Driving in the rain can't see the rearview mirror? Try these tricks!

02

First do a simple cleaning of the window to clean up the dust and impurities that can be seen on it. Then wet the soap and apply it evenly over the window glass.

Driving in the rain can't see the rearview mirror? Try these tricks!

After the entire glass surface is evenly applied, wait for the soap on the glass to dry out. The dried soap is powdery and easier to wipe off.

Driving in the rain can't see the rearview mirror? Try these tricks!

The hydrophilic part of the soap destroys the surface tension of the water droplets, which makes the rain hit the glass without forming water droplets, but instead fuses with other water droplets on the glass to form a huge film of water.

Why does the wiper always scratch clean?

Strips of water marks

Cause: The wiper blade is not in full contact with the glass or the wiper is damaged.

Measures: If there is any dirt attached to the tape, it can be cleaned with a rag and then gently rubbed with fine sandpaper. If the wiper is damaged, it needs to be replaced in time.

Misty droplets

Cause: Grease is present on the glass or wiper of the car.

Action: The driver can use a neutral cleaner to clean the grease from the glass or wiper.

3

Makes a strange noise

Causes: Wiper rubber strip wear, connecting rod mechanism aging, wiper arm spring elasticity decreased.

Measures: Check the wiper arm or wiper linkage bushing and replace the wiper with a new wiper in time.

4

The strip has cracks/hardening

Cause: Wipers are of low quality, corroded by chemicals or exceed their "useful life".

Measures: Hardened wiper strip is difficult to soften, only replace the new wiper strip.

Wiper jump brush

Cause: When encountering a jump brush, most of them are the angle of the wiper strip is incorrect.

Measures: You can use fish-billed tongs to clamp the wiper arm, if it is an upward scraper jump, twist the wiper arm downwards, and vice versa. If no matter how you adjust it, you can't solve it, it may be caused by the aging of the wiper blade, and you need to replace the wiper with a new one.

Driving on rainy days, safety first

Drivers should slow down

Turn on in time

Wipers, marker lights, fog lights

Maintain a safe distance

Source: Shantou Public Security

Huidong County Public Security Bureau official WeChat

Produced by the Office of Public Relations

Read on