In our daily home life, there are occasionally some small headaches, such as a clogged toilet. Once this happens, it can be extremely annoying. Normally, most friends will choose to find a professional dredging master to repair it, but this is time-consuming and costly. In fact, when the toilet is clogged, we can easily dredge it by ourselves by using an item that every family has, and the method is simple and fast. Let's follow me to see the specific operation steps!
This little item is the transparent tape that everyone has. The method of using transparent tape to dredge the toilet bowl is very simple, it is inevitable that a little water stains or other impurities will be splashed around the toilet, we first prepare a little toilet paper, wipe all sides of the toilet with toilet paper, and wipe the moisture and stains on the surface clean. The purpose of this step is to make the adhesive tape more conformable and firm.
Next, we glue the transparent rubber along the edge of the toilet bowl, from one side to the other, and so on until the entire toilet bowl mouth is covered. When gluing, it is best to overlap each tape with the upper tape to completely cover the toilet bowl so that it forms a closed space and does not allow it to breathe.
With the toilet completely covered, we press the flush button of the toilet again. When the toilet is flushed, it will produce a certain amount of gas, but since we cover the toilet mouth completely, these gases cannot be discharged from above, which will increase the pressure of the toilet drain. Next, we press the middle of the tape back and forth with our hands several times to press this gas into the inside of the toilet bowl to form a pressure in the toilet pipe, so that the stains blocked in the sewer can be flushed off, so that the toilet is dredged, the method is very simple and effective.
In addition to using transparent glue to unclog the toilet, we can also use a plastic bottle and two chopsticks to make an artifact to unclog the toilet. Let's take two unused chopsticks, overlap the small ends of the two chopsticks, and wrap the overlapping parts around a few times with adhesive tape to connect the two chopsticks into a long stick. Of course, if you have a long stick at home, you can just use it.
After the chopsticks are connected, we will dispose of the plastic bottles again. First cut off the bottom of the plastic bottle a little, we only need to use the upper part, and the lower part is not needed.
Next, we remove the cap and poke a hole in the middle of the cap with an electric soldering iron, which is about the same size as the thickness of the chopsticks. After the hole is poked, insert the chopsticks that have just been connected into the hole of the bottle cap, and then put more hot melt glue around the chopsticks to make the chopsticks firmly fixed to the bottle cap.
Next, we screw the cap with the chopsticks back onto the plastic bottle. Then use scissors to cut the opening part of the bottle vertically into a tassel shape, so that the plastic bottle can better adapt to the size of the toilet drain. All of them are cut, and an artifact to unclog the toilet bowl is ready. Let's take a look at how to unclog the toilet.
We only need to grasp the end of the chopsticks that are not connected to the plastic bottle, aim the bottle mouth at the spout of the toilet, and then grab the chopsticks and twitch back and forth.
In the process of pumping back and forth, the sewer of the toilet will be pressurized, and under the action of pressure, the blockage inside will be slowly loosened, and the toilet can be dredged. But we make our own one, save money and fast, the key is that it is just as easy to use. After using it, we will clean it and put it in the corner, it will not take up space, and it will be taken out again when we need to use it next time. If you also have a clogged toilet at home, we can use these two methods, which are simple and easy to use. If today's article is helpful to you, then click a follow, a like, and thank you for your support.