Internet access in the living room is as fast as shuttle, and internet access in the room is as slow as a turtle? Broadband Jun has sorted out several major misunderstandings of the router placement for everyone, and see if this pot should be carried by the router!
1, the router puts a corner, the signal to play peek-a-boo
Place the router as far as possible to avoid the corner, the small corner can not let the router completely let go of the fist and kick Oh! It should be placed in a spacious place, such as the center of the living room, so that the signal can be transmitted to every corner of the home.
2, the router sleeps on the floor, the signal is all absorbed
The material of the floor is easy to absorb the WiFi signal, and when the router sends the signal, it actually sends it down. If you let the router sleep on the floor, then it can only contribute the signal to the floor!
3, next to the home appliances, the signal continues to be interfered with
Keep your router away from your home appliances, as almost all products that use electricity can interfere with the WiFi signal and affect network speed.
So, how to properly position the router?
1. The antenna is cross-amplified, and the signal reception effect is good
When the antenna inside the electronic product is parallel to the antenna of the router, the received signal is the best. Therefore, the antenna direction of the router is best determined by the placement of the electronic products, and the effect of operation will be better!
2, signal amplifier, WiFi coverage is wider
If the router signal at home is poor and the coverage is small, it is better to use repeaters and amplifiers to significantly increase the transmission range of WiFi, and even use cans to make simple amplifiers!
3, regularly reset the router, work for a long time to "nap"
The router is too old, too hot, and the running time is too long, which will also lead to reduced signal coverage, so you can consider resetting the router at the appropriate time, or temporarily shutting down to let it rest, Oh, the signal will return to stability after restarting the rest.
(Content Source: Internet)