Recently, a rider reported
Say he changed lanes on the dotted side of the "dotted solid line"
It was captured
Originally
This friend should be the general
Longitudinal reduction line
Confused with the common dotted solid line
What is the deceleration reticle
The deceleration line is used to remind the driver of the vehicle to slow down in front of the road, usually set in front of the curve, slope, tunnel opening, long downhill section and other sections of the road that need to be decelerated or in the lane of motor vehicles, divided into the lateral deceleration marking of the lane and the longitudinal deceleration of the roadway.
Dashed solid reticles
Longitudinal deceleration reticles
Distinguishing between a dashed solid line and a longitudinal deceleration line is actually very simple
The dashed lines of the dashed solid reticles are rectangular
It is different from the diamond shape of the longitudinal deceleration line
And there are also differences in the location where the two appear
Everyone should pay attention to discernment
Whether the longitudinal reduction line can change lanes
Is it necessary not to change lanes?
Of course not!
Whether the vehicle can change lanes
Or depends on the lane dividing line
Solid lines cannot change lanes, dashed lines can change lanes
▲ The figures are all longitudinal deceleration lines, where the lanes where the laneway dividing line is a dotted line can change lanes, and the lanes where the lane dividing line is a solid line cannot change lanes.
So remind everyone
This "dotted line" is not another dotted line
Encounter a diamond-shaped longitudinal reduction line
Be careful!
There are also the ways in which the following reticles pass
Have you all mastered it?
Yellow dotted line
The yellow dotted line is used to distinguish lanes in different directions, usually set on a narrower road surface. When the yellow dotted line, the vehicle can overtake or make a U-turn across the line, but it must be safe.
White dotted solid lines and yellow dotted solid lines
When the middle of the road is a white dotted line, the vehicle can change lanes from the lane on the side of the dotted line to the lane on the side of the solid line, but cannot enter the lane on the side of the dotted line from the lane on the side of the solid line.
When the middle of the road is a yellow dotted line, the dotted side can turn around or turn under the premise that there is no car or guarantee safety in the opposite lane, while the vehicle on the side of the solid line is not allowed to press the line or cross.
In short, whether it is a yellow line or a white line
As long as it is a solid line, it is a "wall"
Can't roll, can't cross!