vSpere Web Client 克隆虚拟机后网络配置修改问题

      当使用VMware的克隆技术时，它克隆出虚拟机的是配置是一致的，包括网络方面。导致

Mac地址也是一样的，解决方法如下：

先注释掉后面eth0和eth1网卡的信息，然后重新启动服务器，让他们重新生成新的eth0的mac地址。

[root@mysql01 ~]# cat /etc/udev/rules.d/70-persistent-net.rules

# This file was automatically generated by the /lib/udev/write_net_rules

# program, run by the persistent-net-generator.rules rules file.

#

# You can modify it, as long as you keep each rule on a single

# line, and change only the value of the NAME= key.

# PCI device 0x15ad:0x07b0 (vmxnet3)

#SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:50:56:85:2a:3f", ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"

#SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:50:56:85:2d:08", ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"

SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:50:56:85:2d:08", ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"

在配置ifcfg-eth0即可

[root@mysql01 network-scripts]# cat ifcfg-eth0

DEVICE=eth0

TYPE=Ethernet

HWADDR="00:50:56:85:2d:08"

ONBOOT=yes

NM_CONTROLLED=yes

BOOTPROTO=none

IPADDR=192.168.1.80

NETMASK=255.255.255.0

GATEWAY=192.168.1.249

IPV6INIT=no

USERCTL=no