Foreword: ed201/6 electric hydraulic pusher is suitable for lifting, metallurgy, mining, ports, docks, construction machinery and other mechanical transmission mechanism deceleration or parking brake. The emg pusher is characterized by smooth braking and frequent action. The main oscillating articulation point does not require self-lubricating bearings, transmission, long life, and lubrication during use. The installation size meets the requirements of gb633-1986 standard.
(Si Cheng He Jing/Photo)
Working environment temperature: -20 °C ~ +50 °C the relative temperature of air does not exceed 90% Of the surrounding working environment can not have flammable, explosive and corrosive gases.
Short adjustment time.
High reliability
Approved continuous work s1.
There are no restrictions on commutation operations.
The motor rotates in any direction and does not need to replace the contactor.
Easy to install and remove.
Easy to adjust travel restrictions from the outside.
Continuous automatic lubrication and wear-free operation extend service life.
Continuous extension of lifting and/or landing times by installing valves.
Depending on the operating conditions and requirements, the level of the operating medium needs to be added to the optimization without additional checks.
Must not be overloaded in operation.
At the factory, the ed201/6 thrusters have been loaded with hydraulic oil as required. If this pusher is stored for too long (more than 6 months), unscrew the screw plug before use and check that the oil level is correct. If the oil level does not reach the specified position, hydraulic oil should be added to the specified position, otherwise the emg pusher will not work properly. Hydraulic oil grades can be used with mobil, shell other standard hydraulic oil, the filled hydraulic oil must not contain impurities or dirt (should be filtered). When filling hydraulic oil, the pusher should be slowly pushed up and down a few times to discharge the gas in the hydraulic cylinder and ensure refueling.
Note: The ed201/6 thruster must be reliably grounded according to electrical specifications! NOTE: When wiring, cut off the power supply and put up a "Someone is working, do not turn off" sign at the power switch. Until the end of the wiring. When connecting, remove the junction box of the emg pusher (the reverse side is the wiring diagram) and place the three-phase power cord (phase sequence is not required) and the ground wire as required. The lid of the junction box is closed and the screws are tightened. Note: The ed201/6 pusher protection rating is IP65. The cable must be sealed by a packing box (user-provided).
The above is all the content of the work principle of the EMG electric hydraulic pusher brought to you by xiaobian, I hope you will like it. For more related models, please collect Ningbo Sicheng~