SMT chip processing workshop requirements for dust-free environment

<h1 class="pgc-h-arrow-right" data-track="1">

</h1>

SMT SMT processing and production workshop for the dust-free environment generally higher requirements, because the SMT processing belongs to high-precision electronic processing, a good SMT processing workshop environment for the quality of product patches is guaranteed, the following Intrali small editor to the majority of friends to chat, patch processing workshop on the dust-free environment related requirements

The SMT processing workshop mainly has these requirements for the environment, namely the load-bearing capacity of the plant, the vibration and noise requirements, the requirements of the gas source, the requirements of the power supply, the exhaust requirements, the lighting requirements, and the working and production environment requirements

First, the load-bearing capacity of the plant should be greater than 8KN/square, the vibration should be controlled within 70DB, and the noise should be controlled within 70dBA

Second, the requirements of the gas source can use the factory gas source, and the oil-free compressed air machine can also be configured separately, but the clean and dry purified air requires the compressed air to be degreased, dusted and watered.

Third, the requirements of the power supply are generally single-phase AC220, three-phase AC380, and the power supply rate is greater than more than one times the power consumption

Fourth: exhaust air requirements, reflow soldering and wave soldering equipment need to be equipped with exhaust fans;

Fifth: lighting requirements, the ideal illumination in the plant should be 800-1200Lux, in the inspection, rework, measurement and other work areas should be independently installed local lighting.

Sixth: the working production environment requirements, this piece is very important, the workshop temperature should be controlled at about 28 degrees, humidity should be greater than 4% RH;

The plant is kept clean and hygienic, no dust, no corrosive liquids and gases; the ground should be painted with anti-static floor paint, grounding wires must be grounded, and employees should wear anti-static clothes, shoes, hats and gloves to operate the operation.

In today's rapid development of electronic product patch processing, backward technology and production methods will inevitably be eliminated, Jiangxi Intree is committed to building a benchmark for Industry 4.0 smart factory, welcome friends to Fuzhou, Jiangxi to investigate Intrali.

This news is collected and sorted by The Small Editor of Interrid electronics, if you need to reprint, please indicate the source: http://www.intelli40.cn