Step 1: Select raw silk with clear latitude and longitude and fine workmanship, spread it flat and cut according to the horizontal and vertical silk of the silk fiber, the cutting size should be slightly larger than the picture, so that the silk can be easily stretched and easily pasted on the wooden frame prepared in advance.
Step 2: Find the edge of the cropped silk, and carefully cut the silk to fix the edge reinforcement on the loom, because the edge line is heavy and the thickness of the re-weaving will cause the shrinkage force to increase, which is not conducive to the balance of power of the silk picture, and also affects the flatness of the picture.
Step 3: Prepare the wooden frame to be mounted silk and the wooden board to be used to lay the bottom draft, and the size of the wooden board should be slightly smaller than the inner edge of the wooden frame, so as not to tighten the wooden frame during the shrinkage of the dry and wet changes.
Step 4: Apply the paste evenly and repeatedly on the wooden frame of the mounted silk (the ready-made paste purchased by the stationery store can be used), it is best to apply the paste 2 times in advance half an hour in advance, so that the wood surface no longer absorbs the paste, and then it is safer to apply it twice before the silk.
Step 5: Roll the cut silk into a round barrel, gently glue one side of the silk first, and slowly unfold the silk along the wooden frame on the wooden frame.
Step 6: Roughly spread the silk, grasp the edge of the silk with the palms of both hands, slowly tighten the four sides of the wooden frame in turn, do not use your fingers to pull the silk, with the fingers to pull easy to make the silk force unbalanced.
Step 7: Place the gelatin particles in glass or other containers and heat the gelatin with water until the gelatin particles are completely dissolved.
Step 8: According to a certain proportion of the choice of alum in the cool water container naturally dissolved, the amount of alum depends on experience, generally with the tongue to lick the feeling of bitter taste can be.
Step 9: Mix the alum glue and use a wool brush to evenly brush the front of the silk with the glue alum.
Step 10: After drying naturally in a light-protected environment, apply alum glue on the reverse side of the silk every other day. In general, it is possible to use the front and back sides of the silk once. If necessary, alum glue can be applied during the drawing process.
New Chinese style living room peony worker stroke ¥1399 purchase