Generally speaking, there are two common ways to reinstall the system:
The first is to use floppy disk, Rufus, Ventoy or Etcher and other programming software to directly flash the official image to the USB disk, similar to the way of direct installation with CD-ROMs;
The second is to use third-party tools such as Youqitong and WinPE to make a PE disk, and then copy the system image to the USB disk for image installation, which can generally be used with an official image, a packaged image or a Ghost image;
The above two reinstallation methods are relatively simple, there are many online tutorials, not the focus of today's introduction, we are going to introduce the third reinstallation method today, one line of code can be done. Here are the detailed steps.
1. Back up your important files stored in the C drive.
Many people like to put a bunch of files on the desktop (C disk is not limited to the desktop), if the system is not optimized after the last reinstallation, the files on your desktop are all in the C disk, because the later system installation will empty the C disk, so be sure to back up your important files stored in the C disk in advance;
2. Enter cmd with Win+R on the keyboard, then press and hold ctrl+shift+enter to run as administrator, and enter the following code:
bitsadmin /transfer a http://win11.link %cd%\1.cmd&1
As shown below:
3. Enter the code and press enter, and wait for the progress to be loaded.
4. The progress is loaded, and you will enter the installation selection interface;
5. Select the system you want to install, we demonstrate here to choose "8" to install Win11 Chinese 64-bit Professional Edition; The system warmly reminds you to back up your data;
6. After pressing any key, start to automatically download the official pure system, the download speed is still very fast, the bandwidth is different, and the download speed may not be the same;
7. After the download is completed, it will prompt: restart the computer to automatically install the system, and after restarting the computer, it will automatically enter the system installation interface;
8. Wait for the progress bar to run out, and then enter the familiar system setting interface;
9. Follow the prompts step by step here, until the Internet interface, some students may be cute, I don't have the Internet or I don't want to connect to the Internet. Can you just skip this step? The answer is: Yes, you can see the above picture "I don't have an Internet connection", press and hold shift+F10 on the keyboard, and the cmd command prompt appears; Enter the code: OOBE\BYPASSNRO and enter, the system will come back to the system settings interface, when you operate to the above step, you will find that you can skip it, and then continue to operate, and you will see the familiar interface;
At this point, the system reinstallation is complete.,The next thing is to activate the system.,I won't describe it here!