When you go out to drive long distances, many riders will prefer the highway, because there is no intersection on the highway, there is no reverse driving, and the speed is stable. Mainly because on the highway, the speed of the car is one, and the danger of some simple accidents has become greater.
Today, Tutu will give you a summary of driving on the highway. We should pay special attention to several dangerous road sections, because nearly 90% of accidents will occur here, in these road sections we should take precautions and prepare in advance, can avoid many dangers, after all, there is no safe road section only safe driving habits.
Highway ramps
In fact, from the toll station to the main highway through a relatively long and large angle of the curve, too fast will lead to insufficient tire grip, the vehicle will have the risk of sliding or rollover, so we must fully slow down before entering the ramp, and the speed should not exceed 40. In addition, the ramp in the service area is relatively short, and excessive speed is likely to cause the vehicle to rush into the green belt, so it is necessary to reduce the speed to below 60 as soon as you exit the highway and enter the ramp. Therefore, whether it is a toll ramp or a service area ramp entering the expressway, you must slow down in advance to prevent the vehicle from losing control.
Acceleration lane
After entering the acceleration lane, we must control the speed reasonably, do not rush into the main road, and do not rush to grab the main road vehicles, many novice drivers do not look at the rearview mirror after the diversion line directly into the main road, it is easy to catch the rear car off guard. If there is a vehicle behind you, you should slow down, wait for the car behind to overtake and then follow closely into the main road, after merging into the highway, do not rush to the left lane continuously, drive in the right lane first, look in the rearview mirror, and confirm that it is safe to change lanes to the left.
High-speed entrance
When we pass through the high-speed merge entrance, try to drive in the left lane, which can effectively prevent direct contact with the merging vehicle, and at the same time observe the movement of the merging vehicle, and be sure to keep a distance from it after finding that there is an incoming vehicle, so as to prevent the merging vehicle from changing lanes continuously without looking at the rearview mirror.
High-speed exit
The high-speed exit can be said to be a high incidence of accidents, many drivers because of missed the high-speed exit, will emergency braking, continuous lane changes, emergency lane changes, and even reverse, if you want to get off the highway, you must change lanes to the right lane two or three kilometers in advance to prevent missing the exit. At the same time, if there is no need to get off the highway, it is recommended to take the left lane and keep a safe distance from the vehicle in front to prevent it from being affected by other vehicles' emergency braking and continuous lane changes.
High-speed tunnels
The light in the tunnel is poor, the speed of the vehicle slows down and the lane narrows, it belongs to the accident-prone place, affected by the poor line of sight, when you just enter the tunnel, you will not be able to see the specific situation in the tunnel clearly, if there is an accident vehicle at the mouth of the tunnel, it is easy to have a rear-end accident. Therefore, before entering the tunnel, you must slow down in advance, turn on the lights, try to take the left lane, if there is an accident or vehicle breakdown in the tunnel, do not park the vehicle at the mouth of the tunnel, as long as the car can still drive, either drive out of the tunnel, or park in the emergency lane.
Inside the corner
The high-speed speed is very fast, in order to offset the centrifugal force of the vehicle, the slope of many corners is designed to be relatively large, which will lead to water accumulation on the inside of the curve in rainy days. And by the middle of the green belt of the obstruction reason, after the curve of the inner bend, the line of sight is blocked, the observation distance will become shorter, if there is a faulty vehicle in the curve, it is likely to be too late to brake after the discovery, so after passing through the high-speed curve try to go outside, do not get too close to the green belt.
Long descents
Many high-speed sections in mountainous areas are long-distance downhill sections, and the most test at this time is the braking performance of the car, especially for the drum brakes with poor heat dissipation, if you step on the brakes for a long time to slow down, it is very easy to overheat the brakes and appear thermal attenuation, and even insufficient braking force and brake failure. Therefore, after a long downhill section, be sure to slow down, widen the following distance, maintain the highest gear of the vehicle, use the engine to reverse the trailer to slow down, and refuse to accelerate sharply, brake sharply and coast in neutral.
Foggy sections
If the highway passes through mountains or rivers and lakes, there will often be fog, after entering the fog, the visibility will drop sharply, and many novice drivers will brake sharply out of their knee-jerk reaction, which can easily lead to rear-end collisions. When we see the fog warning sign during driving, we should slow down in advance to prevent fog, even after entering the fog, we can not brake suddenly, the correct way should be to brake slowly, avoid rear-end collision, and turn on the double flashing and car fog lights at the same time, and slowly drive out of the fog section.
Construction section
Before entering the construction section, the road will be narrowed, be sure to change lanes in advance, and never see the construction section of the reminder sign is still overtaking, otherwise you will only hit the roadblock. And the speed limit of the construction section will be lower, the speed limit will drop sharply, from the speed limit of 120 directly to 80, many novice drivers are afraid of speeding, they will step on the brakes sharply, which is easy to lead to rear vehicle rear-end collision, or even a chain of rear-end collisions, so when passing through the construction section, be sure to change lanes in advance to slow down and pull the driving distance.
The above nine road sections, for friends who often run high-speed, should pay more attention, pay attention when passing by, slow down in advance and pull the distance, only in this way can we avoid accidents in ourselves, in order to maximize the protection of their own and others' personal and property safety. Do you have anything else to add to this? Welcome to leave a message to discuss.