Use Revit to draw the steel structure glass canopy at the top of the ramp: let's not draw the steel structure, just replace it with the curtain wall mullions, anyway, the renderings:
CAD elevations
Ramp top plan
Finish drawing and loading the project renderings
Here's a simple step to how I draw:
- First, set the grid and elevation according to the drawings (the drawings require the entrance height of 2400, the lower basement entrance 1000, the length of the roof 26450, the width of 9100, and the four sides of the ramp top are picked out 500 (longitudinal) and 600 (transverse) respectively)
2. Draw the surrounding curtain wall with the curtain wall, and modify the outline according to the requirements of the drawing
Paint the 2400 and 1000 high glass curtain walls first
Edit the outline as required by the drawing
3. Draw the ceiling with the stitch roof glass window, edit the slope to cancel the original custom slope, and use the arrow custom instead to be more practical, because the drawing gives the length and height, and the ramp still needs to be calculated;
4. Edit the grid of the curtain wall and ceiling according to the drawing, and finally generate the mullion on the grid. The curtain wall grid picks 600 from the outside of the entrance, the first grid starts with a spacing of 1450, the rest are 1700, the ramp top grid, the outside lift is 500, the inward is 2000, and 2050.
5. Finally, load it into the original project and adjust the next position.