What are the main points to pay attention to when installing and using the swing gate
The swing gate is an intelligent channel management device that realizes orderly passage through exquisite mechanical structure, electronic integration, microprocessor control and advanced reading and writing technology. Below, we will give you a detailed guide to the installation and use of the swing gate, so that you can easily master this high-tech access tool.
1. Installation: The installation steps of the swing gate are very simple, just follow the following steps to complete:
- Check whether the swing gate equipment is intact and whether the random accessories are complete.
- Determine the placement position of the swing gate according to the installation location.
- Draw a line on the ground, determine the position of the swing gate base plate, and remove the box.
- Place the base of the swing gate chassis and open the expansion screw hole.
- Use an impact hammer to punch four expansion screw holes (hole depth 110mm-120mm) and insert expansion screws.
- Adjust the horizontality and verticality of the box, tighten the nuts, and complete the installation of the swing gate.
- Use of swing gates:
- The swing gate can be connected to an external access control system, such as card swiping, fingerprint and other access control systems, or external consumer machines and other equipment.
- When passing, personnel should stand inside the yellow safety line of the turnstile to ensure that they are within the sensing range.
- When the green light is on, it means that the channel is open and can pass smoothly.
- If reverse traffic is required, you can press the button on the swing gate and wait for the passage to close before passing.
- In the process of use, if you encounter a failure, please cut off the power supply in time and contact the manufacturer for maintenance.
In conclusion, the installation of the swing gate is relatively simple and can be completed by simply following the steps above. During use, ensure that the device is properly connected to external devices such as access control systems, and follow safe operating specifications.