Change the lens headlights to the headlights today. Because the original headlight reflector is not very good, so change it. But I changed it before, and I changed it for the first time, and the workmanship was not very good.
The current lights are high left and right low, left high and right low, and the two are still unbalanced, so now it is necessary to dismantle it again.
・ Redo it, there are not many tools used, just these two, this is the sleeve of size ten. There are not many screws for this lamp, just one here, one here. There is also one in the front bar. First remove the screws, disassemble these two and break them directly, it's as simple as that. Then this is the screw of the lamp, now it is necessary to remove it.
After dismantling this, first remove these two as well, there is another one in this position, but only the upper front panel must also be removed. There are a total of four fixing screws on this top, which must not be removed, and there are four more below, just one here, one here, and the same over there. Then you can open up a little.
The main thing is that there is also a screw in it, which must be removed a little to get it. The headlights are removed, and there are some additional parts on them, and these should be removed.
Anyway, all the screws on the lamp can be removed. There is also one here, and then add these fasteners, there is no need to disassemble. Because it doesn't matter if you open the shell, and this circle of white screws, remove it in one circle.
Then find a cardboard box just enough to fit the light, and then make a small hole here and use the hot air heater later. The hot air fan does not need any industrial type, you can blow your hair at home, and you can blow it for twenty minutes. Barely put it down, and then cover it. The requirements are not so high, as long as it is covered and slightly insulated. In this way, it does not have to be tightly buckled, there must be a little wind coming out.
Then now turn this on to turn on the hot one to the first gear, the hot one to the second gear, and the wind speed to the first gear. The hot air heat will be a little greater, blowing for twenty minutes. After sleeping for twenty minutes, I can now start looking at the cover, and one hand is still difficult to operate.
・This can be pried open with a slightly longer driver from a corner, as long as you pry it a little, you can directly break it by hand. This one is easy to unscrew as long as it is hot. This prying a little bit can directly break it with both hands, you see these breaks are just like this.
Now while this glue is still soft, quickly clean up the glue, try to clean up as much as possible, and clean it up. Then when the time comes, it is necessary to reuse the glue, which is called snake glue, and it is specially used for this lamp.
After disassembling, you must first say that the black is the original light stand of the headlights, and then this piece of iron is the universal bracket that is matched, and it is not said that the universal is specially equipped. There are these two holes on it, and the two holes over there are not compatible with this lamp, but they match with the shelf. The front is because the lines of the two lights are not together, so now I have to change this one. Corrected and now start to install, this can be installed directly here, no need to take it to the house.
In short, this change of lights must be installed on both lights in the car, after the lights are adjusted, and then close the cover, the last time is to forget, is to think this step is troublesome, so today you have to rework again. Although there is still a little incomplete, the one on the left is still on the low side, and this one is too lazy to move again, so that it is non-professional.
