In clothing design, the neckline and shoulder areas are always the most eye-catching positions, and we need to decorate them.
Introduce a few ways to model the neckline in summer, without making the neckline more distinctive ~ hope to give you inspiration for any shirt that can be used in the summer ~
Bow neckline modeling
The opening is located at the bottom of the neckline, through a strap that has been sewn into a ring.
- Draw a line as the depth of the neckline
- Transfer the thoracic province to the middle of the anterior piece, see figure.
- After the provincial transfer, we draw an extra cutting line.
- After the split, leave a margin for the folds and modify the line in the middle of the front part.
Modeling of the ship's neckline
In this model, the collar is wide and the collar itself can be tied into a tie and fastened, allowing you to stay on your shoulders.
- Cut it according to the figure identification bit, transfer the front and back shoulder provinces, and modify the line.
- Cut the sleeve along the middle of the prototype drawing.
- Tie the sleeves together with the bodice, see picture.
- Draw a raglan line and re-divide the bodice and sleeves, see picture.
- We outline the lines of the neckline and the width of the collar.
- Please note that the collar needs to be slightly above the shoulders, as shown in the picture.
- The sleeves are shortened and the two halves are put together again, and the sleeves are a raglan cut.
- Simply lengthen the front collar to get a tie length of 15-20 cm.
- Outline the neckline streamers, smart outfits.
- I fixed the lines of the sleeves and collars.
- These are the details we get.
Asymmetrical neckline modeling
A beautiful shirt with interesting details, I love its originality.
- We will transfer the province to the cuffs, which are necessary for the freedom of movement of the sleeves, see figure.
- We outline the lines of the sleeves and don't forget to deepen the armholes.
- We outline the lines of the suture surface, see figure.
- We cut along the middle line of the front piece.
- In the left part, we outline the curve, see figure.
- These are the details we get.
Model the open neckline on the dropped shoulder side
A funny shirt by fashion designer Silvia Tcherassi,
It can be said that it is quite special.
- Cut out the province and outline the depth of the neck.
- We outline the lines of the dropped shoulders and deliberately deepen the armplates.
- Mark the ends of the shoulders, which will help to further shape the width of the neck.
- We outlined the width of the neck based on the photo and cut out the excess part of the shoulder.
- We first outline the lines of the collar on the details of the front film, because it will be located in the finished product, and then according to these lines, we will make the collar ourselves, see the picture.
- Don't forget that the collar is double, that is, folded in half. Be sure to cut it and place the cloth along a diagonal line, which is a must, otherwise it is uneven.
- The back is modeled in the same way.
- That's what we end up getting.
The above is all about today, like the small partner can click to follow me