Before we have designed many kinds of inclined roofs, such as the general inclined roof, the front mold oblique roof, so how to design the inclined roof in the car mold? Today, I will share with you two common sloped roof design methods in automotive molds, hoping to help you.
1 Design this type of inclined roof to pay attention to: because our oblique top die angle is 12 degrees, the angle of this surface of the inclined top is 2 degrees greater than the ejection angle, as shown in the following figure:
2 Design at this time should pay attention to the design benchmark, convenient processing positioning, the number of contacts as shown in the following figure:
3 Oblique top fixing method: the use of straight top bar pin fixing as shown in the following figure:
4 Tilt top bar fixing method: fixed by MISUMI standard parts
5 The overall structure diagram, as shown in the following figure:
Then today's sharing is here, and then it will bring more interesting knowledge and content, and will also share UG modeling related small knowledge and tips, interested partners remember to point a point of attention, do not miss the wonderful content after ah ~ ~
UG 3D modeling, assembly design, engineering drawing, motion simulation, reverse design, finite element analysis