High-altitude test equipment| where is the hot and cold shock test chamber better placed?

　　The cold and thermal shock test chamber is an indispensable test equipment for the metal, plastic, rubber, electronics and other materials industry, which is used to test the material structure or composite material, and to be tolerated in an instant by the continuous environment of extremely high temperature and extremely low temperature, so that the chemical changes or physical damage caused by thermal expansion and contraction of the test sample can be detected in a short period of time. Moreover, the cold and heat shock test chamber is larger than the constant temperature and humidity test chamber as a whole, so it will not be placed twice after fixing. So where is the best place for the hot and cold shock test chamber? In view of this problem, the following high-altitude test equipment xiaobian will introduce it for everyone.

　　1, cold and thermal shock test chamber should be placed away from the heat source, not by direct sunlight, because the work is necessary to exchange heat with the outside world and dissipate heat to the outside world through the condenser, the higher the external ambient temperature, the slower the heat. Increase power consumption, poor cooling effect.

　　2, the compressor should be placed in a place with low humidity, because the test chamber shell, condenser and compressor are metal materials, if the control humidity is too large, it will make these components rust and shorten the service life of the test chamber. At the same time, the humid and overheated environment will cause surface condensation and affect the performance of the machine.

　　3, should be placed on a flat and solid ground, and keep the compressor level, which is not only for the need of safety, but also to make the compressor work smoothly, reduce vibration and noise.

　　4, should be placed in a well-ventilated place, if the test box around the pile of debris or too close to the wall, is not conducive to heat dissipation will affect the cooling effect.

　　5. It should not be placed in a place where the temperature is too low, because the temperature is too low and the compressor is difficult to start.

　　6. It should not be placed in an environment of flammable, explosive and corrosive substances.

　　The above about the placement of the hot and cold shock test chamber is shared here for everyone, in addition to the point to note that the hot and cold shock test chamber should pay attention to the power supply capacity when connected to the power, do not use multiple machines at the same time, so as not to produce pressure drop, affect the performance of the machine, and even cause fault downtime, tripping, etc.