Creating a Swap File

To add a swap file:

Determine the size of the new swap file in megabytes and multiply by 1024 to determine the number of blocks. For example, the block size of a 64 MB swap file is 65536.

At a shell prompt as root, type the following command with count being equal to the desired block size:

Setup the swap file with the command:

To enable the swap file immediately but not automatically at boot time:

To enable it at boot time, edit /etc/fstab to include the following entry:

The next time the system boots, it enables the new swap file.

After adding the new swap file and enabling it, verify it is enabled by viewing the output of the command cat /proc/swaps or free.

本文轉自 Art_Hero 51CTO部落格，原文連結：http://blog.51cto.com/curran/1357742，如需轉載請自行聯系原作者