PAP的簡單實作

僅簡單記錄了一下自己使用dynamips模拟器，在CISCO 3620中配置PAP的過程！

注意：以下僅為Router1的配置，Router2的配置和Router1的配置極其類似！

Router#enable

Router#configure teminal

  ^

% Invalid input detected at '^' marker.

Router#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#hostname Router1

Router1(config)#aaa new-model

Router1(config)#aaa authentication login default local

Router1(config)#username router1 password 0 router1

Router1(config)#interface serial 0/0

Router1(config-if)#encapsulation ppp

Router1(config-if)#clock rate 64000

Router1(config-if)#ip address 192.168.1.1 255.255.255.0

Router1(config-if)#ppp authentication pap

AAA: Warning, authentication list "default" is not defined for PPP.

Router1(config-if)#ppp pap sent-user router2 password 0 router2

Router1(config-if)#no shut

Router1(config-if)#

00:06:04: %LINK-3-UPDOWN: Interface Serial0/0, changed state to up

Router1(config-if)#^Z

Router1#write

00:07:35: %SYS-5-CONFIG_I: Configured from console by console

Building configuration...

[OK]

Router1#

00:11:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up

Router1#ping 192.168.1.2

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 16/76/220 ms

Router1#  

本文轉自tiancong 51CTO部落格，原文連結:http://blog.51cto.com/tiancong/159854